How to spool line onto a baitcaster 

Very informative 👌 little tip put your fresh line in a bucket of water this stops its from spoiling to much

Thank you so much for this video ❤

I typically don’t tie a knot on mine. I run the line in one of the holes on the spool and slowly turn the handle so that the spool makes about 5 full revolutions. After that I pull the line right and reel it. I used to tie knots for them but I felt like that kept screwing up the way the line sat on the spool so I stopped doing that. Fishing is a personal enjoyment so do all of it whatever makes you the happiest. 👊👍

Your supposed to go all the way around the spool. The best knot I have found it a uni knot with 4 loops so the knot is not to big

I found that feeding the line through like how you did ends up cutting the line very easily. Maybe it’s just my reel but I had to tie around because those holes are not rounded off for me

How about a smooth reel 🤔?

Such a W video

Finally a video that actually makes sense

I have the same reel

I have a question ❓ is it necessary to add backing to a bait caster reel

👍🏿

How to know if my spool is full

Can I put 20 pound line

Hey busted while you said hi

Or get a Team Lew's Pro-Ti Baitcast Reel

Yeah. Not all reels have those holes on the spool. Not helpful at all.

Oh no you aren’t supposed to use a towel…. the fish can smell it and not want to bite

I tied this knot and it slipped. I think with an arbor not you're supposed to go over hand knot around the main line, and then another overhand knot with the tag end around the main line again.

ya because i know what an “armor knot” is

I'm confused

All i see is your hand

Your answer is far worse than the video. What doesn't make sense Not good at explaining what !

Knots irrelevant. All spools are different

Not a good video do not watch.

Very bad. Don’t make sense. Not good at explaining.