Тёмный

How to use a Brake Bleed & Fluid Extractor 

Supercheap Auto
Подписаться 75 тыс.
Просмотров 220 тыс.
50% 1

Available in Australia: bit.ly/2XiCp0c NZ: bit.ly/2twfZee
Do you find brake bleeding a tedious task? The Toledo Brake Bleeder and Fluid extractor makes it a pain-free, one person job.
The Toledo design relies on compressed air to make fluid extraction easy - and super quick. With a 1.6 litre per minute extraction rate, and a 1L fluid reservoir - the job will be done before you know it.
In the kit is a flexible, and a firm suction hose. A rubber hose adaptor, bleed nipple adaptor; and two hanging hooks. Connection to an air compressor is achieved by means of a quarter inch thread in the bottom of the gun. Just install your choice of air fitting, set the compressor anywhere between 90 and 170 PSI - and you’re ready to go.
If you are replacing the fluid entirely, you might like to begin by sucking the old fluid from the reservoir. Remove the bleed nipple adaptor for this, and use the suction hose to quickly draw the old fluid out. Replace it with some new fluid; and leave the cap off for now.
Always begin bleeding brakes at the wheel furthest from the master cylinder. Using the rubber bleed nipple adaptor; connect the brake bleeder to the bleed nipple. Now loosen the bleed nipple a few turns; and squeeze the trigger on your Toledo Brake Bleeder.
Watch the fluid that flows down the tube; and pause occasionally to check and top up the reservoir if necessary. Should the fluid drop too low; air will enter the system - and you’ll need to start again. Once you’re confident you have pulled the new fluid through; you can tighten off the bleed nipple, remove the brake bleeder, and proceed to the next wheel.
Repeat this process for each corner of the vehicle, and be sure to keep that fluid level topped up as you go. Once the final brake caliper has been bled; top up the reservoir one final time - and replace the cap. Oh, and always test the brakes with the vehicle running, and stationery - to ensure everything is safe.
Whether you’re bleeding brakes every other day at work, or just want to make life easier in the home workshop - the Toledo Brake Bleeder and Fluid Extractor makes it easy.
---------
Supercheap Auto Website: bit.ly/1FpfKkw NZ: bit.ly/2rK6Lg5
RU-vid Channel: bit.ly/2sjZ92q
Like us on Facebook: bit.ly/1Ry7HuN
Supercheap Auto Blog: bit.ly/2skbVOE
---------
Watch our latest and greatest television ads, Check out our how to videos, product videos or learn how to check it!

Опубликовано:

 

21 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 61   
@henkraanhuis3816
@henkraanhuis3816 2 года назад
Great video , short and to the point , no waffling !
@alfredomarquez9777
@alfredomarquez9777 5 месяцев назад
The "BGS" brand is exactly the same, but comes with an automatic brake fluid replenisher bottle, which has much less risk of running dry the reservoir and have to start again all the process...
@hekthic
@hekthic 5 месяцев назад
Just make sure you close the valve for the caliper before you turn the vacuum off
@joshuau4575
@joshuau4575 3 месяца назад
What happens when you don’t?
@danialtahir6584
@danialtahir6584 3 месяца назад
@@joshuau4575 air gets back in
@Robdutton91
@Robdutton91 2 месяца назад
@@joshuau4575air will get into the system through the bleed nipple
@nikozafiratos749
@nikozafiratos749 2 месяца назад
@@joshuau4575 good chance air backflow into the system.
@cipriansofineti346
@cipriansofineti346 Месяц назад
don't you need someone else to push the pedal ?
@cecogeko19
@cecogeko19 2 года назад
thanks my contractor has used many of these before, but the one we purchased for this particular job is heavy duty, no regulators, thus, its a little confusing to work with. there are multiple 1/4 valves. it seems to be working properly, i just needed some reassurance
@rapaent
@rapaent 2 месяца назад
So... There's no need to pump the brakes?
@Robdutton91
@Robdutton91 2 месяца назад
Exactly
@Wayne_Nero
@Wayne_Nero 4 месяца назад
I have tried a few of these and had zero success
@HiRevEk
@HiRevEk 2 года назад
Every vehicle has their own specification of which caliper should be bleed first to last. This video stated the general rule of starting to bleed furthest from the master cylinder but in vehicles like Honda they start at the the closest.
@vesza
@vesza 2 года назад
Including a Civic 2009 Civic Type R specifically?
@Jude13able
@Jude13able 4 года назад
Is it possible to do all four brakes at one time, as long as the reservoir is being topped off?
@mikedelta1679
@mikedelta1679 3 года назад
Yes.
@Jude13able
@Jude13able 3 года назад
@@mikedelta1679 Awesome thanks
@mikedelta1679
@mikedelta1679 3 года назад
@@Jude13able :)
@alfredomarquez9777
@alfredomarquez9777 5 месяцев назад
The german "BGS" brand is exactly the same vacuum pump, but their kit comes more complete, as it has a replenisher bottle that automatically refills the brake master cylinder reservoir, preventing it from runnig dry, and risking air to get into the system, necessitating one to repeat the entire process.
@cipriansofineti346
@cipriansofineti346 Месяц назад
@@alfredomarquez9777 do you have a link please? I need to replace the fluid on a ABS system car.
@furyontech9288
@furyontech9288 2 года назад
can i use this for clutch fluid bleeding too?
@LuisMartinez-om3tz
@LuisMartinez-om3tz Год назад
Yes
@cipriansofineti346
@cipriansofineti346 Месяц назад
So don't you need someone else to push the pedal ?
@mamsongmai
@mamsongmai 2 года назад
Does it need air compressor ?
@freestyla101
@freestyla101 2 года назад
Yea
@alfredomarquez9777
@alfredomarquez9777 5 месяцев назад
YES... it needs at least a compressor capable of reaching 100 PSIG, and more importantly, having at least 5 CFM of air flow.
@ArleneCurrier-b2h
@ArleneCurrier-b2h 4 часа назад
Labadie Valley
@Juppie902
@Juppie902 2 года назад
Can it be used without a proper air compressor ? I dont know, a bicycle hand air pump ?
@NicholasCox85
@NicholasCox85 Год назад
No. You can buy different hand operated bleeding pumps if need be.
@retiredoldsarge5938
@retiredoldsarge5938 3 года назад
Will this bleed the ABS System Module when replacing the master Cyl on a 98 Monte Carlo?
@mayhem661616
@mayhem661616 2 года назад
Yes. It will also extract a sperm sample if you put the hose on your bell end too.
@mikedelta1679
@mikedelta1679 6 месяцев назад
No.
@mikedelta1679
@mikedelta1679 3 года назад
Unless you clamp the brake hose and then push the piston back before you bleed a calliper you will have old fluid left in your callipers. Note 1, don't tighten the clamp tightly.
@cecogeko19
@cecogeko19 2 года назад
thats the purpose for extraction. since the piston is not compressed during a fluid exchange, contaminated fluid is never pushed into the lines to the master. dirty fluid stays in the caliper and thus, is the first to be extracted using the pneumatic vacuum method.
@mikedelta1679
@mikedelta1679 2 года назад
@@cecogeko19 If you do not clamp the brake line and then push the caliper piston back the old and dirty fluid stays in the slave cylinder Franky. If you don't push the dirty fluid out with the piston, the dirty fluid stays there because the new clean fluid simply comes in one hole in the piston and goes out the nearby hole to the brake nipple. Similar happens if you don't pump the dirty fluid out of the master cylinder.
@bednarz5able
@bednarz5able 6 месяцев назад
@@mikedelta1679 the same thing happens during engine or gearbox oil change, you will never get all out which is completely fine. But you will get all brake fluid out if you for example are going to rebuild you calliper when all the fluid is then drained out of it. So it seams to be a handy tool.
@mikedelta1679
@mikedelta1679 6 месяцев назад
You seem to accept defeat real easy Bed @@bednarz5able
@JohnWayne-gl9ig
@JohnWayne-gl9ig Год назад
but what if air is trapped in the ABS module?
@WalterAllen-l2m
@WalterAllen-l2m 3 дня назад
Brekke River
@lukerobinson5175
@lukerobinson5175 4 года назад
do i need a air compressor for it
@emroy.129
@emroy.129 4 года назад
no, but it helps.
@mikedelta1679
@mikedelta1679 3 года назад
Yes
@EnnTomi1
@EnnTomi1 Месяц назад
yes you do, for the user emroy129 i guess he is sucking it with his mouth
@DarrenBoxhall
@DarrenBoxhall 3 года назад
This is actually wrong. They are working on a Patrol, you start at the brake proportioning valve above the rear diff.
@FelicaSchmalzried-f8h
@FelicaSchmalzried-f8h 20 дней назад
Anderson Christopher Taylor Mary Brown Eric
@OPTIMUS6LTR
@OPTIMUS6LTR 2 года назад
thats intents.........
@CRN8091
@CRN8091 Год назад
Like camping?
@OPTIMUS6LTR
@OPTIMUS6LTR Год назад
@@CRN8091 the RU-vidr “intents” Alex’s brother
@Alex.G
@Alex.G Год назад
Team effort, Alex behind the camera 😉
@josephjordan4421
@josephjordan4421 4 года назад
To
@JazzFunkNobby1964
@JazzFunkNobby1964 4 месяца назад
Overkill. All you need is someone to pump the brake pedal.
@Robdutton91
@Robdutton91 2 месяца назад
And how do you do that when you’re working on your own mr smarty pants?
@JazzFunkNobby1964
@JazzFunkNobby1964 2 месяца назад
@@Robdutton91 You pump the brake pedal yourself duh.
@EnnTomi1
@EnnTomi1 Месяц назад
@@JazzFunkNobby1964 and how you gonna tighten the nipple while doing that?
@JazzFunkNobby1964
@JazzFunkNobby1964 Месяц назад
@@EnnTomi1 You can buy a one way valve that attaches to your bleed tube. Place the tube and valve in a bottle to catch the purged fluid. Pump the pedal until fresh fluid comes out the bleed nipple and then tighten the bleed nipple. The one way valve prevents any air going back into the brake line. So easy to do.
@rockyp3917
@rockyp3917 2 года назад
Does it need an air compressor?
@NicholasCox85
@NicholasCox85 Год назад
Yes.
@alfredomarquez9777
@alfredomarquez9777 5 месяцев назад
YES... it needs at least a compressor capable of reaching 100 PSIG, and more importantly, having at least 5 CFM of air flow.
Далее
How to do a Complete Brake Flush and Bleed
12:53
Просмотров 11 млн
Ozoda - Lada (Official Music Video)
06:07
Просмотров 1,8 млн
LIFEHACK😳 Rate our backpacks 1-10 😜🔥🎒
00:13
One Man Pressure Brake Bleeding With Sealey VS820
7:48
ECS Tuning: How To Bleed Your Brakes
7:24
Просмотров 743 тыс.
Ozoda - Lada (Official Music Video)
06:07
Просмотров 1,8 млн