What if your battery doesn't seem to weaken in sound it just stops firing when it runs low on power?.. Because my nuprol 11.1v battery doesn't sound like it gets weaker it just seems to stop working when it gets weak/dead..
1:37 I did the same thing but the recharge doesn't start. How come for me it pauses and doesn't start if I press start again? I set nimh since the pack to be recharged is this one.
Thanks for taking the time to share this. Something I have yet to have someone explain, under the battery voltage (while charging) is what I think is the capacity of the battery but I have never seen mine show a capacity even close to the capacity of my lipo pack I'm charging. Is it supposed to show the capacity of the lipo battery pack in total? Any information will definitely be appreciated. Thanks
you can use NIMH just so you get peak voltage over what you need.. 1s 3.7V.. so charge it just to something between 3.2-4.2 and switch between charging modes really fast.... it takes a minute until the voltage, calms down to thze actual voltage. i aint electrician, i just know it works for me and i know that if i let it run longer than minute on NIMH i would forget its on wrong setting and had to deal with fire anyway
How do I reset the whole charger memory. I had LiPo selected and started my settings and now I can get it to go back into LiPo and it is stuck in LiIo.
The charger will beep when the battery is full. If you miss the initial beeping then the screen will flash with a message letting you know the charge is complete.
Charge speed is based on chargers amperage output setting. Depending on what the small charger is designed for, I’d say yes, this one is able to charge faster since you can set it to a higher amperage setting. Although it’ll likely wear out the battery faster.
Thank you soo much dude for your time , i already killed 2 lipo batterie 😂, so am learning, i have ( 450mah / 100c / 3s / 11.4 / 5.13w ) what should i do to charge it ? I already buy the same charger b6
I guess it theoretically could (in 5s Li-Ion mode) if you managed to jury rig the connectors. The balance lead on the charger is JST-XH, but I've no idea how you'd go about wiring that to the batteries. Would be best to just get a dedicated device for your use case and not play around with potential lithium fire hazards.
@Frontline Foam thanks for that. i have another question.... I'm trying to balance charge a powerbank, the cells are in parallel with 3.7v each, 20 000 mAh capacity. do i desolder them and charge at 1C ? I was aiming for half 1C since the Imax is 6amp max, and that is super high. much appreciated!
@@chrispfeif5552 you should be able to charge at less than 6amps. I believe the lowest is 0.1amps. You’ll probably want to charge @3.7v or less and a low amperage, but the amperage really only determines how fast it will charge, so that’d be up to you.
