How To: Wear Ring Replacement 97 GTX

Подписаться 973

Просмотров 11 тыс.

50% 1

In this How-To video we will be removing the pump and then removing the old wear ring and installing a new wear ring. This process is very similar for many models, and the 140mm pumps and the 155mm pumps.
Get your Delrin wear ring at www.osdmarine.com

Опубликовано:

16 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@benrelyea7962 4 месяца назад

Is the 97 Seadoo GTX wear ring size 140MM? I have 2 GTX’s and both need wear rings. Figured you might have an answer for me. Thanks!

@GCEXTREMEMN 4 месяца назад

Yes. If they have the 787 engine. The 951 engines got the 155mm pump

@rudyshoplopez7366 3 месяца назад

When this are worn do you hear line a rattle noise of metal? I have 2002 GTX RFI and it kinda rattles

@GCEXTREMEMN 3 месяца назад

@rudyshoplopez7366 no they all rattle a little..when its worn you lose forward propulsion. Itll rev up but not move in the water

@rudyshoplopez7366 3 месяца назад

@@GCEXTREMEMN thanks for the reply, good to know

@leeyou7490 Год назад

Maybe can you help me with my GTX not driving more than 10 mph just finish to rebuild the mikuni kit. But I not think this is the issue I think the previous owner mix gas and oil in a same tank Maybe this can be the problem? Maybe this water pump?

@gurieivanov9530 Год назад

Are you sure you got spark in both pistons? I had a problem like that once and all it was I forgot to connect the throttle shaft at the bottom of the carb. Stupid mistake but you never know….

@nightbarber 2 года назад

Do u haft to take out the drive shaft to pull the pump off or can u just un bolt the pump and it slide off on a 98 waverunner?

@GCEXTREMEMN 2 года назад

I dont know anything about Yamaha Waverunners. My channel is for Sea-Doo skis.

@2-smoke Год назад

No, you do not need to take the driveshaft out to remove the pump.

@lakeboy2764 5 месяцев назад

Ya I was sure you didn't have to take the driveshaft out

@wilsonandj 2 года назад

Why do you work on/restore seadoos mainly and not yamahas too? I must say my 95 seadoo xp 720 is more fun than my 97 yamaha gp1200 though.

@GCEXTREMEMN 2 года назад

Cuz I prefer Seadoos and thats what I know. I know the 717cc and 787cc and 951cc engines and carbs.

@MrSdrust Год назад

You’re going around your ass to get to your elbow carbon seal does not have to be done just for ware ring

@GCEXTREMEMN Год назад

I usually replace the carbon seals with new ones on all used machines anyways, and I usually replace them with carrier bearings anyways. I sold this ski for $2800 with no trailer. A $50 new seal/carrier isn't a huge issue and its a peace of mind for the new owner.