I demonstrate how I hooked up the switch panel to run my engine test stand, while also explaining how you could simply wire this into a car application.
You are a life saver man. I’m not sure why I didn’t get it when other people tried to explain but the way you put it everything just clicked. Thank you !
hey man, i used one similar it was jtron with a single switch. it will crank and crack but no start, i don’t have any spark. is there something i’m supposed to do to the dme since it can’t scan a key
What steering column do you use with this? I need one that has a shifter on it but doesn’t have a lock mechanism if you don’t have a key. This why I’m wiring a starter panel
I would suggest two things, either keeping the key in, or take apart the steering colum and remove the locking pin and putting it back together, I will be here if you have any questions, and you most likely won’t find any steering colum of your car that doesn’t have a locking pin in the colum
Maybe your button is one that has two modes, on and off, like a light switch, and not one that just engages when being pushed? (sounds like its feeding electricity through it even after you release your finger so that its on "on mode", try another switch, one that engages only when pushed)
Yes, it does have a led in the start push button. However, I have not put on a ground nor hot lead so it does not light in this video. I got a new phone with a better camera, and am going to remake this video shortly. It will be hooked up in that one.
