How to wire and configure a Hikvision Access Controller 

Glad it was helpful!

Same question here!

Thanks 😊

Yes, you can! You would need to use Weigand wiring protocol for any third-party reader into the Hikvision Controller.

Yes, absolutely

Hello, Thank you for the interaction, the resistors shown at out of the box and also in the wiring example are actually both types Piezoresistors. Piezoresistors are designed to protect the relay in the controller as well as to prevent maglock burn-in when a change in resistance when it is strained. This is demonstrated as bridging across the Lock+ and Lock- which wires to V+ and V- on the maglock and not across the relay. This is as per the manufacture CE approved guides. Whether these are wired on the maglock, halfway down the V+ and V- cable or at the controller end does not make a difference, so long as this is before the relay, in which case this is.

Thank you for your comment. A video of this will be available soon

The software is free to download from the Hikvision website: www.hikvision.com/uk/support/download/software/hikcentral-access-control-v2-0-1/

Thank you for your comment!

How to add third party finger terminal with hikvision 4 door controller

Can you share your mail id for technical support

@@yasirmydeen7845 Hi, the fingerprint reader takes a fingerprint read, and then uploads a card number to the controller to open the door. Due to the fact it requires a half-duplex protocol, this needs to be RS485 wiring which is reserved for Hikvision readers only.