Another good walk around of the naze FC. Be interesting to hear your thoughts on this controller. I'm still figuring out the pids for naza lite. I bought the S500 frame but I will not switch everything over until I get it tuned. Good luck flying and keep posting your flights.
Make sure the flight controller is as close as possible to the center of gravity. Start off with the default settings and go from there. I had the gains linked to the knobs on my transmitter so that I could change them in flight. And also make sure you configure the location of the GPS correctly, this is extremely important too.
This is a great video. I have a question... Have you had the chance to review an "Upgrade NAZE32 SP Racing F3 Flight Control (Deluxe)? I would like some feedback before I purchase. Thanks
Hi sir . One quick question. I have naze 32 rev 6 and i connected all motors, like în ckeanflifht show, but în your video, i seen îs difference.. Why îs that!? Thanks
I have Naze32 (full) and my esc hobbyking 20a ubec would not power from flight control. If I go direct power to esc I can hear that beeping sound. I'm kinda stuck from here and I already watched all the video for Naze 32 on how to connect.
Thanks, I did follow your video but for some odd reason once I put the battery I don't hear the motor beeping or any respond. I believe that I have a bad or not working naze32 flight control, I did order another one though. I'm using rev5 the first one and I order rev6 and I should be getting it today, I will keep you update.
Avec Naze32 Full , Qui peut me dire sur quels contacts connecter un FlySky FS-R9B 8Ch 2.4Ghz RC Receiver 4ch normal mode ? ( Pour un Quadcopter ) ... Thank
+The Ragirate The motors are connected to electronic speed controls (esc), which are controlled by the Naze. I wouldn't use a Naze at all. Go with a newer board.
MultiRotorPaul so the esc signal connector would fire up the motor? sorry im just noob here hehe , I know the has a 2 wire that should be plugged into a battery
+The Ragirate Each esc has 2 wires negative and positive that typically connect to a power distribution board. There's also a signal wire that goes to the flight controller.
+The Ragirate This doesn't apply if you have an all in one esc. Where there is a single ESC, with 4 signal wires coming out of it going to a flight controller. That esc also has 4 sets of 3 wires, each set of 3 wires going to a motor. Most people don't use these, but an example of this is one that I used on my XJ470 called a QBrain.
