How to zero gap JRL FF2020C Clipper, 

mine came with no instructions at all

same bro wtf

so when you make a guide line with ur trimmer you can take it out easier and faster with a zero gapped clipper

Or you make a guide Line with a Clipper and take it out with a trimmer

@@tisch853why use a trimmer for the wrong use

Not everyone zero gaps their clippers and its easier to zero gap then to un zero gap

@@CobbInterscope when it comes out fresh of thr box the line up isnt even one side always higher than the other side

@@demiru6022 I was responding to the guy above me not the actual video

it comes with not zero gaped,why not everyone using a clippers is a pro barber yeah?

You have to loose the Blade a bit, so that the tool can fit in. Had the same issue

Yes it will get closer to the skin

@@PsnJerzCity1980 Thank you sir.

Pointless really trimmers will do the job for skin line, then you don’t get risk of marks to the skin, or loud trimmers.

Yes

hahaha 100% real friend, but attention there is a solution, sand each comb by hand with a file on the inside, you can clearly see the place where they rub at the extreme zero gap

@@jch90z depois de lixar não pega mais? Nos pentes?

@@Lucasfadez CORRECT

are you sure

@@clearriver5987 that’s what happened with mine but I managed to get rid of this sound

How u open it

I can't loosen the screw because it's too tight, any tips?

I got to the point that I was about to use a screw extractor kit before finally using a super small, sharp flat-head screw driver (one for small electronic devices) and it got deep enough to pop them loose. Unbelievably tight right out of the box as well.

@@jc9284 I saw a video where you remove them with a screwdriver, as it can start to loosen, but I haven't tested it yet.

Bro me too these clippers are garbo i wanna return them

So…which is d best clipper ? Please and thanks