How to zero gap Wahl Cordless Magic clips To Purchase the Wahl Magic Clips Cordless - goo.gl/gXpP1T To Purchase the blade I use - goo.gl/wSuAMm Follow me on My other accounts SC: thebarberteezy IG: thebarberteezy FB: thebarberteezy503
Damn sort of wondering if i should of bought these instead of my Philips Multigroom for Beard / Body Trimming. Good video, Subbed even though i don't normally watch these types of vids. Consistent content.
I’m glad you mentioned centering the still blade because most zero gap videos ignore that detail. The only thing you failed to mention is that you should first make sure the cutting blade is centered as well.
wait so does the far left tooth of the cutting blade have to be flush with the guide blade? so there is like a little gap between the two first sets of teeth, or do i just make it even on both sides
Hey bro I order the magic clippers to cut my sons hair during this quarantine what comb # is best to use when I always tell my barber to cut them a 3 1/2 on top and a 3 on the sides ? Thanks if you respond
just use a #3 guard and open the lever for a 3 1/2 and close is for a 3. That will be a very easy haircut to do yourself during quarantine. Good luck but I think you got this
Hi there Sir, can i use this after it was zero gapped to trim my body hair?? (chest and stomach). I imagine it would trim very closely to the skin. An answer would really be appreciated 🙏
The first screw will no longer screw tightly in. It’s loose enough for the blades to shift everytime I cut my hair. I try to screw it in until it’s tight but I don’t know why I’ve done for it to be so loose.
Does your cutting blade end up in the same position each time you turn it on and off. just picked up a pair of these and mine ends up all over the place. Ends up on the left /right /middle. no consistency. thanks
it should stay in the same place unless you are referring to it being a little left or right and not centered when you turn off the clipper? That is just the postion to rotor pin is in and shouldn't affect anything unless it is going past your still blade on the sides
had the same thing happen to me i thought my machine was broken 😆 thats how it supposed to be tho ur good. When the machine is on its gonna cut evenly turn on the machine and look at the blade ✅
Nah MOCO, it straight up say on the box STAGGER TEETH blade, made for blending aka fades but for whatever reason lot of the pros switch it out for the regular surgical steel blade..
Why does everyone do this Bro? I’ve seen bossio do it as well , why just not get the cordless designers it’s the exact same and it comes with the taper blade already for cheaper , I have both machines
Is the cutting blade suppose to move a little bit from side to side when you turn it on? I did it on my and the cutting blade I see it move a bit but the guard blade stays in place and zero gapped still
omg I literally just had that problem while trying to do it , I don’t know what I’m doing wrong but it’s really frustrating as I thought I lined it up perfectly
@@kamilluszczyszyn1967 i found out it’s normal bro nun to worry about if you want it in the middle that bad jus turn it on and off until you get it in the middle
@@kamilluszczyszyn1967 it wont effect the cutting bc when the machine is on the blades are cutting evenly, when u turn off the machine thats when itll be on the right/left/middle
I appreciate your concern but I have perfect cholesterol levels, perfect blood pressure, and have been tested dozens of times and am nowhere near even being pre diabetic but again I appreciate the concern
