I guess its a definit loop,and traffic will keep moving in a loop. And its can't be termed as invlan routing. VLANS are subject to do segmentation. Yes if native VLAN mismatch is there it can pass packet as untagged .plz answer,if I am wrong
@@anuphilip1994Because it is wrong. Please read up on Broadcast domains. The switch will always maintain separate MAC address tables for each VLAN. Connecting a cable between ports belonging to different VLANs on the same switch won't enable communication between computers A and B. While the physical layer connection exists, data packets are still tagged with their respective VLAN IDs. The switch, adhering to its programmed configuration, will continue to isolate traffic within each VLAN, preventing packets from VLAN 10 from reaching devices in VLAN 20 and vice versa. For communication to occur, a Layer 3 device like a router is necessary to bridge the gap between VLANs. It understands the IP addresses and routes packets based on their destinations, regardless of VLAN boundaries.
Please make a video on the below question. 1. TCP flags 2. How pat will add the port number 3. What router will add to the ip header before sending it to the other network? 4. Difference between ARP AND RARP 5. how the switch will get to know different VLAN traffic and when switch will send traffic to the router 6. How pat table will look. 7. How to debug connection refused (ping to destination is working fine) 8. Can you make a video on trace-root ( please explain briefly) 9. can you please briefly explain OSPF NSSA and stub? 10. Why do we need OSPF multi-area design 11. DHCP message (DORA process and why DORA process is broadcast). 12. How switch will get to know VLAN 10 and VLAN 20 traffic. 13. When to use static nat and dynamic nat.
Hi..sir I need one suggestion from you sir,I have 2 poe Cisco cbs 350 switches and 3 catalyst 48 port switches ,there is no vlans and single network..so can I connect internet from Cisco poe to all switches??and can I apply port mirroring on one poe switch it applicable for all switches or not??
Here you can make the port 0/2 and 0/3 as access port so when vlan data will go no tagging was performed and communication between the devices will be performed. You can also use native vlan concept.