Today’s podcast is an interview with Cold Molded building expert Sean Koomen, instructor at the NW School of Wooden Boat Building in Port Hadlock, WA. This is the fifth of my Interview The Expert series of podcasts focused on 6 methods of boatbuilding: Carvel, Lapstrake, Cold Molded, Stitch and Glue, Strip Planked, and Skin-on-Frame.
With Cold Molded construction, 2 or more layers of wood veneer are glued together (in opposing grain directions) over an elaborate building jig using the vacuum bagging method or by stapling them together, so that the epoxy is uniformly applied between layers. Typically the inside and outside of the hull is sheathed with fiberglass cloth to protect the veneers of the wooden hull.
A cold molded boat is a light, strong, and beautiful monocoque hull - but can be complex and time consuming to build.
During the interview, Sean discusses the following points on Cold Molded construction:
Description and history
Skill level required to utilize this method
Cost of this method versus other building methods Time to build versus other methods
Special tools and materials required
Pros and cons
------------------------------------------------
You can contact me at woodenboatdan@gmail.com to share you
comments, feedback, stories, and wooden boat adventures.
Keep the bright side up and the barnacled side down - Wooden
Boat Dan over and out :D
PS Please note this podcast was recorded several years ago
- some of the links, email addresses, phone numbers, and promos mentioned are outdated and no longer valid.
12 сен 2024
