a guide to remove the solenoid from the drive section- part 2: • HP color M277 59.C0 dr... Other causes of 59.C0: • 59.C0 error unusual so... • HP colorlaserjet Pro M... • HP color M277dw | 59.C... #diy #letsfixit
Thanks for your video. After following your procedure many times, I cannot close the front door correctly. So I take off ITB first, than install gear module, after check the gear function and front door smoothly, installing ITB back. It works. Just share the experience, thanks this video again.
thank you!, too difficult to fully open the drive unit, so i slit in papers between the lever and the solenoid with the small slit available. printer is working normally now
I have an HP LaserJet 500 m551 printer, and I have the error code 59.00.CO as well, It is hard to reach as a non-professional, I was just trying by watching these videos and following instructions which I did base on the nearest model printer that matches mine, I can't take it out based on the location, I was watching a video until he stops there and use a method and took out the entire bracket that holds the gears and solenoid, so I didn't see the last part how he did it, so I came up with my own method to get rid of the sticky padded piece, " but It wasn't sticking at all, but I use a long needle to scrapped it off, it moves free, been doing so before i assume it was sticking, base on the test i gave it to check if it was really sticking, I close back up the machine which was the hardest part, as I couldn't remember the step I took, I put in the screws in the holes that I saw empty and so far, it holds together, yet I still have about 6 screws leave back, After I manage to do so, I turn on the printer to now see fuser error, but it hardly comes back, but the error code 59.00.CO returns, yet my solenoid has nothing to stick on to cause a delay...what can I now do to solve this issue.
hello, you mean you will spray the solenoid? i don't think it's possible because that solenoid is not visible..you need a little effort to open it 🙂...thanks.
Good day Sir! Itatanong ko lang sana kung saan nakalagay ang spring na natanggal. Pwede po ba magpa-service sa pagpaayos ng ganitong printer? Baka po magkasundo tayo sa service fee mo po.
Where is part 2 of this. I. Having similar issue with mine...and i tried about 10 times to get it back in but same result. I have taken a big break from this.....its frustrating.
@@tiknik will let you know on Monday when i check it again. I did most of what you did state in this second part. Got everything well closed and lined up. But still get grinding noise and the error 59.C0 error on start up. I'm suspecting I need to line up that solenoid in a specific way with the gear(s) immediately next to it.
Sir may eStudio 5018A model. Yung A3 nagbi blink lang pero naka highlight... Kahit ano press sa start copy wala response. Kumpleto naman papel sa loob tray. Salamat 🙏
Muy buen video, me ayudo mucho resolvi el problema del solenoide, pero ahora tengo el problema 50.3 y la hoja cuando quiero copian no entra al fusor y se atasca, sabes como resolver eso amigo?