Sweet work Dude, I do the same type of stuff down around the Atlantic City area. This is exactly what I like to watch. Keep up the great work Thanks L.U. 322
+Emin HVAC lol i ben watching alot of ur videos u do call bolts nuts alot but i do the exact same thing even when i know its a bolt, bolts an nuts go hand in hand
Emin, Good Job. Ive had those types of bearings seize and pretty much weld itself to the shaft. The only way to get it off was to use lots of heat and cut it off.
If you clean polish, and lube the shaft first, you wouldn’t have to work so hard to get the bearing off. Also, if there was any wear or galling on the shaft where the bearing seats, the shaft should have been replaced.
Yo I have a question, if I wanna replace a bearing, how do you measure the old one? Or do you just get the middle and serial of the unit and give it to your supplier ?
Yeah the big jobs you have to wait for your money. Steve like you said in the commercial field you have to watch your tools. I had 2 drills stolen from me
Rookie or dumb as duck lol clean shafts first. Then u only need to break it loose and will slide off. Also have cut or smash casting then puller fits onto bearing itself. I have done hundreds of these . Easy work made look difficult for sure