Commercial AHU Pillow Block Bearing Replacement | Hammer And Elbow Grease…💪 

Yep, was a little work out . Thanks Steve 👍

Thanks 👍

You never know until you start throwing some tools at it how hard it will be . Thanks Jason 💪

Oh yeah 👍 I guarantee the old pillow would keep you up at night, now I can sleep well 😴

Much appreciated 👍

Thanks for watching!

Yeah the set screw was in the shaft key, had to drive it cw , I locked it down like the gorilla before me. Thanks for the comment

Thanks for watching!

Yep, Next step would’ve been drilling out

@@subcoolHVAC I thought you were gonna have to.

The thought was crossing my mind but I had all day if needed this time. Thanks for commenting!

Definitely was a loud one, Thanks for watching

Thanks!!

I replaced the other side prior to this job and it’s the same bearing. I would think fixed are what you find on a motor shaft, is that what you’re asking?

Yes, didn't remember if the fixed was close to the motor shaft, thx @@subcoolHVAC

Thanks, just showing up to work is all the attention I need 😎

@@subcoolHVAC love your work mate :)

That was replaced 6 months prior

Sure did 👍

@@subcoolHVAC I got an engineered air pillow block to change and I quoted 6hrs for both sides 😩 a part of me regrets it big time

Well the goal is set, you’ll get it done 💪

Or my last 🥺Thanks for watching

Only one issue, when you shut off the disconnect, would have been nice if you put a LOTO on it. These are training videos and safety is is the best training. Other then that, great job.