HVACR: How To Remove/Replace A Fan Blade/Blower Wheel From A Motor (How To Use A HVAC Blade Puller) 

Wow! Just did one yesterday but I didn’t use the Allen claws just used the screws to tighten down but now I know claw way. Thanks!

Interesting subject. Well presented and explained. Great 👍 job JMT

Great presentation as usual. Thanks for sharing your knowledge.

Nice wrenchs have the same from harbor freight nice vid, thanks

Thank you so much great video👍👏

I spray Kroil down the shaft, then remove the set screw and spray a little in set screw hole

Did you clean the axle in front of the blade and add oil first? Can you tell me how to get a cast aluminum blade removed from a steel shaft?

Great video. Thanks for the explanation very clear.

Is this type of puller a one-size-fits-all? Or are there different sizes? If the latter, how do you determine the size needed?

What size socket is that?

What if you don't have that claw tool? How do you take the blade?

Great video

Wow. I’ve been doing this for 4 years. And never knew those Allen wrench looking things were to attach to the puller. I never read the instructions! I feel like an idiot😂

How do I get a van??

Great video most helpful a hardy all American hand salute from American Legion Post 346 of Miami Florida 🫡🇺🇸

Buena herramienta

💪💪🇺🇸👍👍