in this video we will be fixing my 1998 Volvo V70 Manual Base model. The slave cylinder failed and needs to be replaced. Unlucky enough it is an internal slave, so we have to remove the transmission to do this job.
Replacing 1998 Volvo V70 Base 2.5l Manual Internal Slave Cylinder
3:53 - Jack Up The Car
5:02 - Disconnect the battery, remove air box, harnesses, etc from above the transmission.
11:31 - Removing the transmission, clutch, and flywheel.
15:15 - Replace rear main seal.
16:01 - Slave cylinder replaced and installed transmission.
19:01 - First start and drive...didn't go well :(
21:13 - Figured out why the new slave cylinder was leaking
Wanna help support the channel? Check out my merch page and snag a shirt and/or slap sticker!
~~~~~~~~~ MERCH SITE ~~~~~~~~~
weekender-garage-merch.square...
Send me something useful or funny :D to the following address:
Weekender Garage
PO Box 46
Gladeville, TN 37090
~~~~~~~~~ Check Out My Build Series Below ~~~~~~~~~
Building A HotBoi Turbo Miata Drift Car In 10 Minutes:
• Turning $500 Miata int...
Turbo Miata Drift Build:
• Hot Boi Turbo Miata
$500 Civic Wagon Build:
• FINALLY Starting on th...
Wife EF SI Hatch Build:
• My Wife Bought Her Fir...
11 апр 2023
