On todays video I will show you how I installed my stock factory LS pushrods and rocker arms on to my Lq9 6.0 after the SS2 cam swap, I really did not even check preload and pushrod length as this is a common swap and the only thing I changed was cam and springs, and the cam I am using really does not need a different pushrod length from what I seen online, if I changed block height or had my heads milled down or was using a super large cam or so on I would of checked pushrod length and preload as not doing so is asking for engine trouble.
Link to bent pushrod video: • HOW TO TELL IF YOU HAV...
The torque specs I found are 22-25 ft pounds for the rocker arms, double check before doing yours, I went to 25-on mine.
This really is not the proper way to install pushrods and rocker arms, I have did a few motors this way and all have been just fine, they are many ways to install pushrods and rocker arms so do your research, this is a video showing you how I did mine.
If you enjoyed this video be sure to drop a like and leave a comment I enjoy hearing from everyone, don't forget to show your support for my channel by smashing that subscribe button!
30 ноя 2021
