Thank you so much. I've never seen the 1/4 turn method before but it makes so much sense. I'll be doing this tomorrow on an old 327 with some freshly built double humps. Appreciate the time and effort you put into the video.
I enjoy all of your videos - thank you for taking the time to teach, show, each step… as well as where you encounter issues (too many videos are edited to only show the ‘successful progress’ and skip over the realistic issues we face when working on cars (especially old ones)
Thank you for the kind words. A lot of times, I am learning as I go along so many times, I run into issues that I was not expecting. I try to show as much as I can without making the video too long and boring. Thanks for watching.
Enjoyed the video, really cool to see how that all goes together. I'm not quite ready to start my own yet, will need to watch about another 10, 000 video's, lol , great job! Sis
Hello I hope you still respond because I have a urgent question. I just first time disassembled my engine like your's in the video and I wanted to ask, how does it work when you tighten the nut back on holding the rocker arm? I am new to all this, and I am constantly thinking the engine oil will loosen it up. My rocker arm is held in place by a nut on top, and some halfround thing with a flat surface, where the nut comes on top of it. I hope you understand what I mean, like is there no security or threadlock needed for the rocker arm installation? 😅 I'd be glad to hear from you 😄
The nut is a self-locking nut. You don't need any thread locker or lock washer for them. Most companies selling car parts recommend you buy new ones when rebuilding your engine. Normal engine operation should not loosen the rocker arm nuts as long as they are in good condition. If you have any doubt, I recommend replacing them.
I’m doing a very similar aluminum head replacement with stock stamped steel rockers. You said Elderbrock gave you a new length. I can find a recommendation for the dart shp heads. Any ideas?
To determine the correct pushrod length for your SBC engine, you would typically perform a pushrod length measurement using a pushrod length checker tool, taking into account factors like cylinder head type, rocker arm type, camshaft specifications, and valvetrain geometry. There are some videos on RU-vid explaining the proper procedure. I would also contact Dart to see if they could provide the correct push rod specs for your setup.
That was Permatex Ultra Slick Engine Assembly Lube, part #81950. I was trying a couple of different assembly lubes during this build. The other one was Sta-Lube. Engine Assembly Lube, part #1007912.