I made a spyderco TANTO 

Missed last weeks upload but new video is here 👍🏼

Good idea

The end result just blew me away, that looks gorgeous.

I got the Cold Steel Recon back when they were $60. My work knife when I was constantly cutting boxes and cords was a Honshu. I can't imagine spending $200 on a pocketknife.

That blade flashing bit with the light was hypnotic. 😵‍💫 When you mentioned the logo it made me think that maybe you should make your own metal stamp with your channel logo for certain projects that you want to put your "stamp" on. 😅

Just something to be aware of: H1 is a work-hardening steel, not a traditionally hardened (with heat treatment) steel due to its nitrogen component. Meaning that the comparable Rockwell scale goes up the more it is worked on. H1 with serrations actually are harder and have a higher comparable Rockwell count over regular unserrated H1 steel because the grinding hardens the steel. I doubt it's a case of it being made brittle due to the grinding, it probably had no where near that of an impact on it, but you might want to be careful stabbing or plying with the tip more than you were before.

Looks nice, Man!

Now that's a knoif.

Quite impressive grind work from the tanto to the swedges! I know a lot of people say that a 2x72 is a must when it comes to knife work but a little 1x30 like that is excellent for mod work in my opinion. Also a thought I assume you’ve had or maybe even attempted but would it be possible to modify and shorten the original scales to create a fully closing knife?

I am major disappoint at the lack of a before and after "that's not a knoif this is a knoif".

I've been trying to find a good folding knife with a decent 3-4 inch blade under about 40 AUD. Any recommendations?