In-floor Pool Cleaning System Troubleshooting 

Thank you for your tips. It was driving me nuts but it was my heater bypass needing a slight adjustment and things started working amazingly again! I really appreciate it.

I'm looking for information on the "pressure testing tool" you spoke of in your video. Thanks.

I had the spa check value replaced 2 days ago as the water levels were below the jets every morning. After replacing it, the water is still lower than the jets in my Spa this morning. Love your tutorials. Do you have one to fix this?

All cleaning heads pop, some not all the way. None of the rotate. The pool is 30 years old. The filter is clean. What next?

New pool with infloor system (venturi heads), 8 months it seems to work only when the pump is at 3000 speed or above. I have all pentair system (intelliflo vsf pen011056) I clean my filters monthly. I have removed the heads and let any debris flow through......heads are fine, filters clean... I'm lost.... not sure about the valves position...I have no features, just a raised 18" spa with a spill over. could it be possible some debris could be clogged in the pump line> the spill over seems strong though,

I have two pop up heads that don’t fully reseat and this not rotating. When I manually push it down then start to rotate again but then a day or so later they get stuck up again. Water pressure is good. Should I try to take them out and clean them?

My spa’s zone is always pushing out some water from the heads, not enough to keep them popped up, but enough to see water flowing out the Venturi top and continuous spillover into the pool. Meanwhile, the rest of zones including the spa continue to come full on and off properly. I am wondering what would cause this.

I have a single head that doesn't seem to receive any water. There are two heads in that zone, but one is completely out of commission. Maybe it is obstructed? What tool or tools are needed to snake out individual outlets?

Question, when our pool was first put in all of my pop up heads would pop up and work in zones and cycle through them all before starting again on the first zone. Now all heads come up at the same time with not enough pressure to move much dirt. Is this because there is an issue with the hydraulic valve not working correctly? Is so, can it be fixed or should it be replaced ? (9 year old salt water pool in AZ).

I’m getting a flapping noise in since my gear box I took the gears out and replaced them cause they was wore down but after replacing them I’m still getting the same noise. What should my next step be ??

My system vibrates/Humming from the gearbox when system is at the steps and deep end of the pool ? The gear unit was replaced about 6 months ago.

after nearly 15 years installed, mine is having a leak at the inlet PVC pipe joint. Not sure what caused this, but seems that I will have to reinstall a new actuator box just for this... I will appreciate any suggestions.

Shouldn’t all the heads start out at a certain position to push all the debris towards the skimmer to suck up all the dirt

This video didn’t really help me figure out how to fix, just telling me to replace. 🙄

How much does a valve cost to replace

yes, backwash the filter should be the first step !