Bro, i just realized there was a smoked version of this 😮. I just recently ordered mine and now i will return it to get them smoked one. Thank god i saw this video haha. The smoked ones look waaaay better although the clear one’s might illuminate brighter.
@@Schizyy DUNTUO Side Mirror Light Led Turn Signal Dynamic Sequential Blink Car Lights Running Indicator Marker Lamps for Infiniti Q50 Q60 Q70 QX30 QX50 QX60 QX70 [Smoked Lens] Left Right Assembly a.co/d/cjTXLki
Wired the blue for the puddles, worked for a little bit. But now my window is weak and wont roll up. Goes all the way down when I open my door have to close it from the passenger side when I get out and the puddle stopped working. Maybe it shorted something? Not sure need to rewire it.
Did you hard wire it to the blue wire ? If you didn’t sometimes it gets loose and can cause a short in your Window switch and window actuator. You’ll have to get them both replaced. It happens on another q60 I had
How did you get the wires into the car (to the RGB controller)? Are the wires exposed when you open the door or did you route through the rubber wire boot?
Also the 2 blue connectors inside door...why are those disconnected, confused as to connection after wires are pulled thru upper door grommet,,,Can U help have sequentials on the way!!!
You disconnect it in order to be able to pull them up throw the upper grommet and tape the wires for the sequential you are installing down that is it!
What’s up man! Just ordered these I saw on 11:37 that you cut that white wire to go with the blue, so with the blue wire did you cut an open gap in order to get the white one in between? Asking ahead of time! Thx.
Yessssir that’s it! To make it easier just cut the blue wire in half. Splice both ends, and then splice a single end on the white one and from there just twist the blue and white wire together with the second blue wire end.
Yo bro sick video so I had my lights installed. But I noticed today that I don’t have a white light it’s just the sequential with hazard and turn signal. They gave me back my old lights and in the box was the blue black white extension cords still wrapped up. Wtf 😑 did they fuck sumthing up or they just need to put the extension cord in? Any advice would help. Thanks again!
Yooo thanks brotha! And it sounds like they did not tape the blue and white wire because the red and yellow wire are for the Switchback(turn signal/hazards)
I wired it same way as you but I don’t know if I shorted something, my driver window goes down but won’t go up but all other buttons work on the switch even passenger window. Any suggestions? I’ve checked all fuses and window mower works
Is there a DDS light that comes on the dash after you installed the coilovers on the redsport? I currently have lowering springs but want to switch to coilovers.
