Infrared Remote Control Cloner 

IR Clone is an open-source infrared remote control signal analysis and generating tool. This utility can clone IR signals, examine the IR remote control signals, and modify or create new IR signals.
This project consists of both hardware and software utilities. The hardware module contains an STM8S003F3 MCU, 32Kbit EEPROM, IR receiver, and transmitter.
The software application provides options to decode captured data and generate new IR signals.
This video shows all the steps of this project including, soldering, uploading firmware, wiring, and testing the IR Cloner.
Additional details and all the project files are available at jayakody2000lk.blogspot.com/20....
Content of the video:
00:00 - PCB of the IR Cloner module
00:07 - Soldering the STM8S003F3 MCU
00:38 - Soldering SMD capacitors
01:50 - Soldering SMD resistors
03:12 - Flashing MCU with ST-Link V2 programmer
03:44 - Soldering SMD resistor network
04:06 - Soldering MMBT3904 transistors
04:41 - Soldering AMS1117-3.3 voltage regulator
05:10 - Soldering through-hole type resistors
05:20 - Soldering electrolytic capacitors
05:45 - Soldering 8-pin IC socket
06:10 - Soldering 6mm tactile switch
06:19 - Soldering LEDs and IR decoder
06:36 - Soldering pin headers and connectors
06:47 - Preparing the test setup with a 4×4 matrix keypad
07:12 - Examine the actual remote control behavior
07:20 - Cloning the remote control
07:33 - Testing the IR Cloner with an original appliance
07:45 - Transferring EEPROM dump to the PC
08:09 - IR Cloner PC application
08:48 - Creating a new waveform profile
09:39 - Transfer modified dump to the EEPROM

Наука