Installing a Rough Country's High Clearance Bumper 18 Toyota Tacoma 

Thank you

ill try and make it

Thank you for your service brother and your comment I wish I was still in but do to my injuries I was med boarded. As for the skid plat I don’t think it would the way it looks like it bolts to the RC bumper and the frame but there may be a work around if u just bolted to the frame and not the bumper. What area u located I maybe driving to AZ today to hit the trail if u are in the area I can drop it to u .

@@bravo-overland Aww man that’s unfortunate… I’m sure you’d still be in if you could, but you did your time and more than enough! I’m probably a little out of range haha I’m in PA. I was just curious, I looked it up and it looks awesome, but I saw how it bolts onto this bumper so I wasn’t sure, I’m not fully ready to invest in the bumper just yet haha. That’s really nice of you to offer up the skid plate like that!

Wiring to the winch wasn’t hard at all. I just ran it behind the grill up to the battery and the hook came with the winch. The brand of the winch is rough country 1200 pound but you’re better off going to Harbor freight and buying one they are much better

the wings came with the holes pre-drilled all you have to do is bolt them onto the central part of the bumper. when I was installing the bumper I was trying to do it in one piece it made it heavy and more challenging to line up so I removed the wings after that the center bumper was easy to install.

I’d like to know too. My winch hasn’t arrived yet but I tried putting it on anyway. Could not get it on. No matter what. Trying again in the morning.

Sorry for the late reply but no it didn’t affect the front radar system. And the bumper works great. It paid for cell off-road in already.

I’ve never tried taking off the grill after install the bumper, but by the looks of it, you have a 50-50 chance that you have enough room to get the grill off that is a great question. I will attempt to take my grill off and I’ll get back to you.

@@bravo-overland thanks for the fast response. I’m close to pulling the trigger on this bumper. Did you also move or buy a rad cooler relocation bracket?

@@JtheInvincible no I did not. I was worried I may have to, but when I installed the bumper, there was clearance between the winch and the cooler by 2 inches so it was perfect.

not for this bumper if you have a lift kit installed you're good.

I don’t sorry.

sorry for the late reply. the light bar comes with a wire harness and switch but its trash. so i cut the switch and rellay off and connect the wires to my Auxbeam 8 Gang Switch Panel. Chase ?????