Introduction on how to use the NP4 Skiver - EPISODE 44

Подписаться 2,5 тыс.

Просмотров 6 тыс.

50% 1

In Episode 44 we discuss and demonstrate a basic understanding and usage of the NP4 Skiving machine from Leather Machine Co. There is a learning curve each user must overcome, but with proper practice skiving your scrap leather, you will begin to understand how to make proper adjustments to achieve the proper skive needed for your project.
All procedure steps are approved and supported by Leather Machine Co.
Follow VAN PLEW CO on INSTAGRAM:
/ vanplewco
Check out our WEBSITE:
www.vanplew.com
LEATHER MACHINE FEATURED IN VIDEO
•••••••••••••••••••••••••••••••••••••••••
leathermachine...

Опубликовано:

27 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@susantipsyhealy7655 Год назад

I’m now a fan! These videos are great

@vanplewco Год назад

Thanks! I’m glad the videos have helped you 😁

@nicokyriak 10 месяцев назад

Nice and positive presentation.

@SerinasCustomLeather Год назад

Thank you Steven!!! I am excited to start using the NP4 now that I have exchanged it!!

@vanplewco Год назад

YESSSSS! Can't wait to hear all about it.

@kimthompson2610 Месяц назад

great video. help. used for the first time, skiver doesn't "sound" right the grinding noise. Leather stops under foot and now I'm getting an ER7 warning . says to check motor connector or machine head? huh?

@manasseh10000 Год назад

Hi could you please please let me know how much thin of a leather this machine can achieve? I am planning to buy one and I need to skive the edges to ultra thin like A4 size paper. Appreciate your information. Please respond and if possible do a short video clip. ❤

@jholden0 11 месяцев назад

Ive had ome of these machines for a few months now and have avoided it because its so hard to get consistency . For some reason, i have to yank the leather through the machine. The roller wheel doesnt pull the leather at all.

@michaelsmith-ep7jq 9 месяцев назад

Make sure the knife is sharp and you're not going too deep or shallow of a cut. There should be no need to yank the leather.

@jholden0 9 месяцев назад

@@michaelsmith-ep7jq thank you. I actually was able to figure it out. I watched your video over and over and suddenly realized that my roller wheel was not close enough to the presser foot. It seats a lot closer than I was initially setting it up to be. It seemed like the gap was way too small for the split to roll downward and not jam the machine. But, I was very wrong. Thank you for the reply!

@helloholmes Год назад

Extremely valuable content. Appreciate the effort you put into this playlist along with the Cobra 26!

@vanplewco Год назад

Thanks Andrew. I’m glad all the videos have helped! More and more will be on the way :)

@helloholmes Год назад

@@vanplewco I look forward to it! Seeing the “why” and the “how” on these tools is so important! The “what” is obviously the fundamentals to the tool but seeing it applied in action makes it all come together. Excited to see more in the future! :)