Tyson I've watched your channel for yrs.I'm getting rid of some tractors. One of them is a 930 case comfort king. All its done is pull a haybine for yrs. Thought maybe some one would need a good tractor. Just thought I'd mention it to you.
Nice having some grass to cut this year. Got 2.9” out of this last blast. Was at Donnelly to drop off a cross auger out of my haybine to get fixed. Looked like they had enough rain without this last blast from peace river down to there.
Hi Tyson. I bought a John Deere 445 and didn't realize it was using a lot of oil. My rings were shot. I think somebody didn't have the air filter on right as one of the fasteners was broken. I ended up getting they cylinders measured and the cylinders were out of spec so I got it bored out at a cycle shop 0.5mm and honed and put in new oversized pistons and rings. I also replaced the front plain bearing and of course all new seals, gaskets, and also the governor. It runs great now with lots of power and doesn't use any oil. My only complaint is it uses a lot more fuel than our Kubota with a 3 cylinder diesel. I use the 445 for snow blowing as well as mowing. I enjoy it very much for snow blowing as the gas engine is easy to start. It takes 1 hour to pull the engine so don't be scared about that. I also printed out a shop manual that helped me with rebuilding the engine. I had never done anything like that before and didn't find it too bad. Just had to be patient and take my time. I am from North of Saskatoon and have relatives in Fairview AB and Fort St. John BC.
My uncle Wesley had the same mower before he passed away I used it to mow our yards the engine blew three different Times over the years John deer here in northwest Missouri charged him over a thousand dollars each time to rebuild it the value covers and oil fill cap will become bridle and crack over time
G day Tyson Boy that Farmall looks really nice. U must be happy driving all these red tractors Boy it is suppose be 90's this week That will be hard on my breathing. Thanks for now
@@Northern_Farmer Frost warning here in Edmonton Area tonight. Seeing snow down west of Calgary. Snow around Hinton too apparently. Winter just needs to go!!!
Thank You Sir.good job on the blades.grass looks like cut with a razor.saves on the horses also.gld you are getting rain.we had some early but looking like 22-23 again.last storm looked like 4th July but barely wet the deck.the mower the cylinder with no compression if you can see the cylinder walls and are good I'd overhaul if big if someone good with small engines was close.keep up the good work.thanks for the good videos.
If you put red implements behind green tractors you really need to be careful. They're not intended to have to handle all that power. The way you do it with green implements behind red tractors it's safer. Waaaaay less power on those red ones teehee.
I have one Similar to that JD Model 512 Still works as it should. Pull it with a NH TC45 works great. On to the mower wonder if Valve seat came loose or valve guide bad, definitely worth pulling apart. 👍🏻
Even them cheaper borescopes that are out there you can pop a spark plug and server the situation. Usually can see bad valves and poor cyclone conditions
we have a z445 zero turn that had a dead kawasaki 25hp. Got a 25hp briggs from princess auto and it dropped right in. surprised how similar it was to the kawi. Allthough it was an air cooled vert shaft.
If you can make the time I’d say hone and new rings. Even if you could check with bore scope it would still have to come apart. You can always change coarse and do engine replacement if tear down shows it’s not feasible for rebuild. Just my thoughts.
Why do you like to be mean to be on my RU-vid channel? Are you this way to everyone? No 2 people are created equal. Are you just joking around? Or criticism. Please answer in a video
