06 22 24 I purchased this about a month or so ago -- was in no hurry. I installed the uprights 1 weekend and ran FEL wiring .. Joystick was a week delay due to this being new and new mfg process - was fine with me... Finally arrived and it has quality feel. Installed as video showed. I did try to run joystick wire with out taking off deck and 1 connector made it and the other was 5 inch short. I did take the deck off and ran it. The power distribution was the trickiest since the throttle cable had some interference, as noted in video. With some fiddling it fits just right. Kind of hard to mess up connector fittings 2 pin to 2 pin 3 pin to 3 pin 4 pin to 4 pin -- .. The only issue I had was the aux power connector @3:54 time mark (single white wire) It seem to fit either way into the JD harness but only 1 way enable the joystick to turn on. If the Red LED does not come on check the orientation of this connector . My test was a pile of mulched leaves 20ft diameter 2 ft high and wanted to make the pile smaller and taller. Handled with with ease. Still on my learning curve but have plans for more use. Worth buying? Absolutely. Support ? I had a few emails back and forth with Dan and Carlos, all timely . The bucket came separately to a freight distributor and they loaded it into the van Plymouth voyager, skid and all . The rest show up about a week later. Final thoughts Buy some fresh drills for the frame holes. Installed on JD X584.
