Тёмный

Jumper R1 V2 Mini | Receiver Range Test 

Pango FPV
Подписаться 256
Просмотров 4,9 тыс.
50% 1

Overview and range test of R1 V2 Mini Receiver by Jumper. Manual says it could go over 4km, so I decided to test if it could really go that far.
Setup -
Aircraft : ZOHD Drift
Receiver : Jumper R1 V2 Mini
Radio: Radiomaster with built-in Multi Module
VTX: Jhemcu VTX20-600
FPV Goggles: Skyzone SKY04L

Опубликовано:

 

21 июл 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 34   
@Michael-jo9jb
@Michael-jo9jb 3 месяца назад
Very good video. Straight to the point with no endless talking.
@AerialWaviator
@AerialWaviator 2 года назад
Nice review and demonstration. Great Drift setup, with rear-mounted camera.
@yuansean7462
@yuansean7462 Год назад
How amazing!I am gonna use this receiver to fly my drift too.
@MienazNafeesa
@MienazNafeesa 2 года назад
Great reciver 👍🏻
@lungomaburfpv1425
@lungomaburfpv1425 Год назад
Thanks, I will try to Frsky X9D+
@sifukeon6786
@sifukeon6786 2 года назад
Mantap, utk fly jauh
@grisvianbrudlie6093
@grisvianbrudlie6093 2 года назад
Hey man i ended up getting the exact same reciever for my very first quad. I notice that unlike many frsky spi receivers, the rssi on this receiver stays at 99, then falls rapidly when certain distance is reached. Is this suppose to be normal?. And again thanks for the repvious reply helped a lot.
@grisvianbrudlie6093
@grisvianbrudlie6093 2 года назад
Hey man I appreciate you taking the time to review this reciever throughly...the jumper reciever was impressive, so is your VTX. May i know what vtx you are using please? Thanks..
@pangofpv
@pangofpv 2 года назад
Hey, thanks for watching. Very impressive receiver indeed. On this airplane I used JHEMCU VTX20-600 with Foxeer Lollipop V3.
@grisvianbrudlie6093
@grisvianbrudlie6093 2 года назад
@@pangofpv Thanks for the info👍
@jeepoyfernandez
@jeepoyfernandez Год назад
Hi sir.this nice range test .can i ask?how you install it in rc plane??you used gyro stabilizer.or sbus to pwm converter.pls.im planning to buy that rx.but confused how to do it ihave before sbus rx. wired the 3 signal.Vccc.Gnd. to sbus to pwm converter and go.are you doing the same wire set up.or just wire to gyro?
@fabianonunes6367
@fabianonunes6367 2 года назад
I couldn't connect this receiver to the taranis qx7 accst, has anyone managed to?
@rafaelgil1542
@rafaelgil1542 2 года назад
Nice review. Which output power was the ELRS module setup? 100mw?
@pangofpv
@pangofpv 2 года назад
Thanks. I didn't use ELRS module, it is TX16S built-in MULTI-module. I'm not sure the actual transmitting power of the module, should be no more than 100mw.
@Sr-fb7wj
@Sr-fb7wj Год назад
God, my receiver can't communicate with F411 flight control. Is there a solution?
@goodmanpurba2998
@goodmanpurba2998 Год назад
How if not find frsky x2 ? In my tx only frsky x ?
@krdozoduvan8764
@krdozoduvan8764 Год назад
Hola, sabes cómo actualizar el módulo?
@bengordon7635
@bengordon7635 Год назад
Do you have to do that will all receivers to get maximum range is there a default on the r-Xrs frisky how the video so far
@pangofpv
@pangofpv Год назад
Ideally you want to do fine tuning for each individual receiver for maximum range. From my personal experience all receivers have different tune even they are same model from same manufacturer.
@bengordon7635
@bengordon7635 Год назад
@@pangofpv I noticed that I have 2 tx800 and 1 gets far reception the other is way shorter
@junosaka4987
@junosaka4987 2 года назад
i using radiomaster zorro 4ni1 with jumper r1 v2 receiver , only can get 500m .......... any idea please help.
@transitionfpv6707
@transitionfpv6707 Год назад
Same to me
@dekoreanang
@dekoreanang Год назад
And I only get 150m... this rx very bad I think
@Ktorome
@Ktorome 2 года назад
Do u have to do a firmware update ?
@yuansean7462
@yuansean7462 Год назад
Using the old firmware,I can't connect the rx
@55amps
@55amps 2 года назад
This or frysky xm+ ?
@yogamustofa5643
@yogamustofa5643 2 года назад
i think better jumper R1 V2, but better test compare with another TX @pango FPV, it's pure perform R1 V2 or not
@leonidich31
@leonidich31 Год назад
а у меня этот приеник не биндится с апаратурой radiomaster t8 Lite
@mohdfadlyarifin2433
@mohdfadlyarifin2433 Год назад
Liked👍🏾. Salam bang,nak tanya ye, saya baru je tadi beli tx16s v4(4in1) dan ada beli juga brg2 elrs( Jumper Aion nano tx, Jumper Aion mini recever, dan adapter utk psg nano tx modul pada slot micro tx di TX16 tu... Brg fpv yg sy beli adalah: google Skyzone sky04X v2, vtx Diatone Mamba Ultra,dan bbrp pcs patch, n spiro rhcp antenna... Projek nya,sya berhasrat nak buat untuk edf jet fpv siap dengan gps autopilot. Kalau dpt flite distance sampai 3-4km pun dah oke je.. Soalannya; info di fpv awak tu dipanggil apa ya? Osd ke,rssi?saya berminat nak buat fpv mcm awak😎👍🏾👍🏾 Dan barang2 yg saya ada ni👆🏽👆🏽👆🏽👆🏽,boleh ke install gps/utk boleh autopilot?adakah cara yg lebih simplified drpd tambah fc mcm APM 2.6? Mohon jasa baik tuan tunjuk ajar yea✌🏾😅
@pangofpv
@pangofpv Год назад
Data dekat video FPV tu dipanggil OSD. Untuk ada OSD kena pasang flight controller dekat kapal terbang. Kapal terbang saya recommend guna flight controller yang guna firmware Inav, macam Matek F405-WTE atau F411-WTE. Saya suggest guna Inav sebab banyak feature untuk kapal terbang dan senang setting banding firmware lain. Autonomous flight kena tambah GPS module.
@mohdfadlyarifin2433
@mohdfadlyarifin2433 Год назад
@@pangofpv ohh..okk. INAV tu programmer nya/mission planner utk fc matek berkenaan ke bang? Kalau fc Pixhawk px4,mmg kurang best ke beza yg fc matek tu?
@pangofpv
@pangofpv Год назад
@@mohdfadlyarifin2433 Ya betul. Inav ni programmer, lebih kurang macam Ardupilot, Arducopter, Betaflight dll. Bukan matek saja, banyak jenis FC dia support. Pixhawk OK ja boleh pakai. Tapi personally saya lebih suka FC lain macam Matek, Omnibus, Mamba. Pixhawk lebih mahal, besar, berat, bulky, module yang compatible terhad, tak ada built in OSD, dan tak support tukar firmware lain macam Inav/Betaflight. Yang bagus pixhawk ni ialah tak payah serabut nak buat soldering, semua plug and play.
@mohdfadlyarifin2433
@mohdfadlyarifin2433 Год назад
@@pangofpv ye jgk ye... Pixhawx cuma advantage pinout connector je,x perlu solder sangat..tapi berat fc,saiz besar,dlm pakej std ni pun sy cuma dpt gps modul,wire2,dgn ade satu pcb kecik ada wire halus2 dgn in&out wired xt60...(agaknye amp&volt sens module) Lain2 sensor xde dpt..taktau la samada dijual berasingan ke.. Tapi sy ade survey2 fc name FuriousFpv F35... Blh jln gps. Nampak menarik gak tu..
@mohdfadlyarifin2433
@mohdfadlyarifin2433 Год назад
@@pangofpv assalam bang. Sy nk tanye ye, mcm mane kaedah buat range test elrs ni? Adekah mcm cara remot JR/Spektrum?, de pakai Test button kat blkg remot..
Далее
NEW Speedybee F405 Wing MINI
12:28
Просмотров 16 тыс.
JUMPER R1 RECEIVER TELEMETRY SETUP
14:57
Просмотров 24 тыс.
ПОЮ НАРОДНЫЕ ПЕСНИ🪗
3:19:41
Просмотров 1,9 млн
ЧУТЬ НЕ УТОНУЛ #shorts
00:27
Просмотров 6 млн
Drone Karen Attack - Police Amazed by video
14:03
Просмотров 152 тыс.
Inside the B-17 Ball Turret
18:59
Просмотров 1,9 млн
MY FAVOURITE Radio of 2023: The Jumper T20S 2.4GHz
12:22
Cara Binding Konek RX Jumper R1 V2
11:23
Просмотров 10 тыс.
Getting Dial Up Internet in 2023!
16:50
Просмотров 943 тыс.
MyFlyDream 200km Delivery
9:48
Просмотров 583 тыс.
Average warm up pack
5:40
Просмотров 361 тыс.
ПОЮ НАРОДНЫЕ ПЕСНИ🪗
3:19:41
Просмотров 1,9 млн