For the coil sub harness, did you wire the following into the MSPNP2, Spark output A (pin 17) from the MS ECU to cyl 1 and cyl 4 coil and B (pin 16) to cyl 2 and 3 coil? For the wiring of 1-4 coils did you crimp or solder the wires together? Thank you.
This is the sub harness I used: www.wiringspecialties.com/honda-k-series-smart-coil-conversion-harness-for-s13-ka24de/ I am on a Link ECU, but all of the flying leads are labeled so you can match it all up. I use heat shrink terminals from Amazon for my soldering, so no crimping. These are them: www.amazon.com/dp/B0CD77KTB6?ref=ppx_pop_mob_ap_share
