I am also a new owner of a older Kawasaki Mule, when I bought it from my friend I knew it needed both boots replaced, this is a great video, looks so easy to replace them.. Thank you
Great video. Could you specify which models share this same assembly? I have removed the drive shaft assembly but am unable to separate the shaft from the outer ball-race. My Mule is a KAF620E vintage 2003 I believe.
Not sure on what other models. usually CV joints are very similar and will have either s circlip or will hit off with hammer. might pay to get a workshop manual specific to your vehicle.
I had a little trouble with this too. Cut out a lot of footage as it took a little to get on. Check that the hub is not getting jammed on the brake shoes. Back off adjustment. Make sure the spline is clean. By memory it was a tight fit.
