The last step on how to open the inner frame is ambiguous in this video but like he says (but doesn't show) you do seem to have to pry that inner frame away far enough to barely access the lower handle screw. I was nervous the whole time because I thought I was going to break something. I did, in fact, crack a bit of the plastic I was using to get the leverage needed to pry that inner frame out but it's not too bad. At least I was able to tighten the handle.
For those of you that came across this and are also trying to do the last step. Mine had more than 1 screw (3 - two on top 1 on left). After you need to pull down on the plastic so the nubs holding the metal frame don’t hold it in place anymore. Pull out on all sides and the entire outside plastic frame will come off. For additional clarity ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-xFVKmUh99Mg.htmlsi=JwxiI1VX-xmjxHoV looks a little like that
Como limpiar la pantalla donde marca la hora de mi microwave es kenmore ? Es el que tiene tostador incluido es como un cajón bajo solo se jala ! Es de acero inoxidable
So I was unclear on your final step. You just pry the two layers apart and then use a screw driver to undo the bottom part of the handle? How do you get the screw driver in there? I also need to replace the handle for reasons you mentioned, actually I bought it several years ago and tried but gave up after removing the entire door but still couldn’t get inside the two layers. Will try again as you suggest, hoping it works this time. Thanks for the tips.