No video :(

KFA Explorer Aircraft Build Video 11

Подписаться 297

Просмотров 1,1 тыс.

50% 1

Video 11, I am fitting the composite wing leading edge cuffs.
Video 12 I will install a few beacon light wires and prepare to seal up the entire aircraft with the covering. If you are interested in learning about the Polyfibre covering system you will enjoy the future videos. I am off to Oshkosh 2024 this week and will be spending sometime with the guys from Polyfibre to learn everything there is to know.
See you on the next one!

Опубликовано:

5 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 2

@coeniethomas1887 Месяц назад

Like following your build. At 4:15 should that cuf not be only halfway on the rib so the next cuff can also be supported by the cuff? Is the cuff at 5:05 not going to "float" now? Should that not be cut like you did later at 12:40?

@brockowen8536 Месяц назад

@@coeniethomas1887 Thank you I appreciate the support, yes you are absolutely right. Once completed I made and installed my own angle to support that cuff. Otherwise it would be floating like you mentioned. With the second wing I cut that cuff a little shorter so they can both rest on the rib. All the learning curves!