Great update I’ve just took my multibay off as it constantly made that noise and used to backup and then start again as if the pump stopped or the line was full of air and put an eazypod in I also have a tempest and the bakki shower. I might use the multibay on a grow on setup I’m looking at building.
I feel your pain! I had a 3000v and it’s only rated for 3000lph and had a 10k vari pump on its lowest setting which was 3500lph and it only just about caught up with the flow. Not sure what model kockney bay that you have but I would just get a 3000lph pump and take it nice and slow the results will be so good with maximum dwell time as it’s not your primary filter doing all the hard work and just polishing the water 👌🏻😎
A proper vari-pump should make all the difference and allow you to adjust the flow to get the best dwell time through the media to have the filter functioning at its best. You'll sort it out. 👍🏻 👍🏻 👍🏻
Vary flow pump 10 k should be ok with that multibay ,ive same one was going to add same size pump to mine ,its all about balancing the flow rate for the pond
Put ball valve on and slow speed of pump to the pond alot better than these electric devices anything goes wrong with them you could loose fish unless you have float switch fitted all the best pal 👍👍
Really like your multi bay setup.could you fit an elbow and then extend the pipe down towards the bottom of the filler and then use another elbow and then fit the cage to that so that you are drawing water from the bottom of the filter so that the pump doesn’t draw in air at the top 👍🏻
Great stuff👍 I do like a good multi bay set up😊👍. Nice slipper too😂🤣👍 are they BKKS recommend 🤔.I’m sure you’ll get the pump sorted and it will all work well👍😊
Once you get the speed right that system will work a treat it's a shame your variispeed isn't working properly I can't tell you if it's the pump or a faulty variispeed but the 2 I have are working perfectly 🤔
Ok ads you can get them ball valves from eco-filtration if you need to replace the Bulkhead you get them from EA I’ve recently replaced the waist slide valve for ball valve on two of my ezay pods