dear, do you know the ratios of the gears? because I want to put 16 inch rims at the back, but then the front ones also have to be bigger and we don't know which one? I have a kubota B6000 and are now 14 inches on it and want to go to 16 inches but then I need to know the gear ratios? can you help me with that or do you know which sizes I can take?
Thanks for video it really helped recon my gearbox. Could you please tell me, on 4x4 shaft ( rear diff end) first is a needle bearing then collar with grove.. Does grove face outward? Thank you
Good mechanic. Fix it all. I'm confused how easy all that bearings go in. For the brocken teeth take a magnetic pen for catch them out the box. In my youth time i fixed Zündapp Mopeds and make them faster. The bearings in this engines fits stronger in cases and the crank. Its intresting me for watch inside little tractors. 👍🇩🇪 Which is the lever for 4WD ?
i guess Im randomly asking but does someone know a trick to get back into an Instagram account?? I somehow lost the login password. I appreciate any assistance you can give me!
@Arian Finnegan I really appreciate your reply. I got to the site through google and Im waiting for the hacking stuff atm. I see it takes quite some time so I will get back to you later when my account password hopefully is recovered.
Hello, i own a kubota M5030 six cylinder and my problem is that the tractor for some reason in slower than should be. It should speed 28-30 km/h and my speeds 18-20 km/h(2200 rpm). It is revs nice and the wheels are stock. What is going wrong? and what i could improve in the gearbox? thanks
do you mean to say the propeller shaft?for the front drive propeller,you need to do is to split transmission from the bell housing because it is very hard to remove the pin from it but if you want to remove cross joint,please watch from my video if you do not already watch on how to remove it.HOW REMOVE PROPELLR CROSS JOINT or just click from my playlist.thank you for watching
tractors&marine MECHANIC I actually need to replace the shaft itself that the propeller shaft slides onto. It’s sheared off at the tip of the shaft where that roll pin goes through. Wasn’t sure what all had to be disassembled once the trans was split from the bell housing
thanks for watching.sir,i have already that video.TL AND TU series model are both the same front axle.pls.subscribe to my channel and find this one.(How to replace oil seal TL2100 ISEKI (L&R) front axle).you can find this one to my channel.salamat.
ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-YVU0OWBW5d8.html The above is one of my video that you can watch and learn that your engine can fixed it.maybe you do not understand my tagalog language but you can see where was the problem or the oil coming from. the cylinder head there is a cover and remove it.just follow on my video.thank you.i hope you understood.
The oil that pushing into the radiator was coming from cylinder and when you removed the side cover from the cylinder there is a small blind hole that you should to fixed it.
sir yung B1902 namin check na namin ang clutch at pressure plate kapal pa pero bakit usad pagong at parang maingay loob ng transmission. ano kaya problema non sir?