Kyosho 2002 WRC Impreza Free Run Gravel 

Why, thank you! I try to make it creative and 'cool' 😎😁 Glad you enjoyed!

Thanks bro, I try to make it creative and stuff.. trying to remember what looks good with the music. Bigbris was right though, she's a squirrely Scooby and desperately needs a gyro. I'm probably gonna throw the 5900kv motor in there so she's definitely be out of control then😆 Glad you enjoyed!

Hey thanks for that, brother! Hope all is well with school, life, and whatnot I have been liking your posts and stuff, just so ya know👍

Glad you enjoyed and yes, this handles a lot like the real thing, it's crazy.

Thanks brother, glad you enjoyed and I definitely got my cardio today 😆

Thanks! I'm going back to this same spot after tuning the shocks and diffs. Should be an improvement in the quality of shots. I had a really hard time holding it straight here, but it looks cool 😁🫡

Thanks! She really needs a gyro and I'll have to come back with the Lancia. That little thing shreds!😁

Thanks brother! Glad you enjoyed it 🤜🤛👍

Hehe, glad you enjoyed it my friend. I'm definitely adding a gyro for future runs. It was impossible to keep it in a straight line at full tilt for more than a few seconds. I put the temp footage just for you as well, glad you commented on that because I was curious to see how it compared to yours! 😁

@@scaleworksRC Ah sweet, cheers for the consideration mate! I've not actually got any official temperature figures for mine..... I just know it's running s**t hot! 🔥 I think I've sourced the issue though.... The bearing on the entrance to the rear transmission is totally seized! The rear prop shaft cup has melted to it and the whole mutilated mass has been spinning around with no bearing motion whatsoever! Everything is now fused to the spur shaft, and the plastic around the prop shaft cup is all mangled. I'm guessing the resistance has put strain on the motor and esc causing excess heat, and eventually limp mode! 🤕 Looking like I need a new spur shaft, prop shaft cups, bearing, prop shaft, upper diff casing and chassis, as the lower part of the prop tunnel entrance is moulded onto the chassis itself! To make matters worse, 4 of the hex screw heads have stripped and will have to be drilled out in order to take the car to bits. Also, the 4th set of tires have totally worn through. Spares availability in the UK is pretty poor, and its now looking quite expensive to.... all in all a major headache! Luckily I've got another 28 cars, this will probably end up being a full rebuild over the winter! As for the gyro..... I will be interested to see how you get on there mate! 👍 👍 👍

@@yodadarksideGreenHawksRC Oh Jesus.. that sounds bad and she's probably down for good. I'd get another car and keep that one for spares and skip the headache! Best of luck to ya sir, and good thing we have plenty of backup cars 😁

@@scaleworksRC Funny you should say that, I have been thinking the very same thing fella! Especially as this car has been heavily run for two years now, the front steering and suspension has developed a lot of slop due to the plastics wearing, and there can't be much left on the brushes at this point (obviously the stock motor is non rebuildable as it's a sealed can) But at the same time, I do enjoy a challenge, and I've rebuilt far worse cars from the eighties and brought them back to show room finish (959, Celica GRB, mud blaster, midnight pumpkin, clod buster, monster beetle etc) But these sort of projects are for the winter. I will have to have a think going forward..... potentially may even buy the chassis only kit that kyosho do? Also considering a full rebuild and upgrade it to rally spec, that could be a fun project! Time will tell, got so many projects on the go, and so little time! All the best matey. 😊 👍 👍 👍

Thank you very much! I truly appreciate that. Check out the latest video where I return to this park with rally block wheels. It came out pretty good as well with the music

Thank you, sir! I noticed in your video you reduced the sound almost completely and it makes the video better! Just a few shots have the motor sound for effect and it works great. The music is from a game called 'Art of Rally' and the artist is Tatreal.

A close foot dodge! Thanks brother, glad you enjoyed! 😁🫡

😁 Glad you enjoyed it brother.. she's been sitting too long!🤜🤛✌

Maybe that's why she's so squirrely.. traditional rally block better?

@@scaleworksRC yeah definitely more grip with rally blocks,sometimes too much but you can cut away some of the blocks to fine tune them . I like the Jetko Couragia tyres as well but pricey . You could also set the tops of the rear shocks to the inner most hole on the shock tower then set the bottoms to the outer holes on the arms .That will soften the rear for less oversteer , standing the front shocks up as vertical as possible will also help reduce oversteer 👍

@@RallyandTrail Ahh, thank you so much for that! Much appreciated

Just a few minutes drive away from home! 😁 Thanks for watching, and glad you enjoyed! 🫡