Landi Renzo Med How to Disassemble an Injector Reconditioning LPG GPL

Подписаться 89 тыс.

Просмотров 16 тыс.

50% 1

Here you can see the products which i used in this video
s.click.aliexp...
In this video I will show you how to recondition landi renzo injectors.
We need a bench vise, and an Indicator Micrometer Tool .Hour Type Indicator Measurement Instrument.
Due to factors beyond the control of CMC DIY, it can not guarantee against unauthorized modifications of this information or improper use of this information. CMC DIY assumes no liability for property damage or damage incurred as a result of any of the information contained in this video. CMC DIY recommends safe practices when working with the tools or equipment seen or implied in this video. Due to factors beyond the control of CMC DIY, no information contained in this video will create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from the improper use of these tools, equipment, or information contained in this video is the sole responsibility of the user and not CMC DIY.

Хобби

Опубликовано:

23 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 14

@electronic7979 Год назад

Very good

@CMCdiy Год назад

Thanks

@suparoachgaming Год назад

Interesting video my friend !

@CMCdiy Год назад

Thank you

@xynostasos9022 Год назад

Hi. Do you think it's worth to recondition the Med injectors? Or it will be better to use petrol-type injectors (e.g., Hana or Keihin)? Have you seen Keihin injectors work OK on Landirenzo Evo or Landirenzo Omegas systems?

@CMCdiy Год назад

I didn't understand why a repair kit can't be made for this type of MED injectors? The ones that fit are Valtek or those that have a coil with a resistance of 1 OHM, they are much cheaper and have a repair kit, while the MED one you can just throw them away

@ernestlageman1553 11 месяцев назад

After I clean my injectors , ( they where very dirty and clean them whit thinner) the engine give now more misfires first only cilinder 2 and now als cilinder 2. But these 2 injectors are making also more noise like klakking. Maby they are at they end of live ?

@mrk454 10 месяцев назад

you should never spray the injector with any sorts of lubricants or cleaners let alone thinners as it kills the rubbers etc.. if you have misfire then replace the injectors

@ernestlageman1553 10 месяцев назад

I replace them whit new ones on my Mercedes w203 but now again gives misfires . The garage said it’s the cheap older Stag ecu in combination whit the rest . He could not read the ecu . But he found a open loop on the lambs sondes . He want to put a new ECU so that the only way he can read the gas installation he said. It was strange because later I ask about the open loop mistake , and after reset it didn’t occur. I have my doubts now on that person

@CMCdiy 10 месяцев назад

If you installed new injectors, a calibration must be done. That is, the opening times of the injectors differ now. It must be connected to the ECU, maybe it doesn't have the right software. It is recommended to go to a special LPG service