No video :(

Laser Quick Tip: Engraving Multiple Tumblers at One Time

Подписаться 31 тыс.

Просмотров 3,1 тыс.

50% 1

The Rotary Attachment allows you to engrave 360 degrees around an object like a tumbler, but if you have to do many of them, you can save time by engraving multiples using this quick tip to combine a jig and the optional 4” lens to engrave further around an object even when it’s not flat.
To receive your free Epilog Laser engraved samples and a brochure visit:
www.epiloglase...
For domestic US pricing and to setup a demonstration, contact your local distributor:
www.epiloglase...
For international system pricing and to setup a demonstration, contact your local distributor:
www.epiloglase...
Epilog Laser
16371 Table Mountain Parkway · Golden, CO 80403 · USA
sales@epiloglaser.com · +1 (303)277-1188 · toll free (888) 437-4564

Опубликовано:

26 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@vidserver5 10 дней назад

Quick question and bit confused: You mention to focus "halfway down" the tumbler yet in the video it looks like the focus is actually on the top of tumbler (since it's being shown lowering). Can you please better clarify exact area to set focus? Thanks.

@RickSwartwood 6 месяцев назад

I wasn't aware you could do these without the rotary. How do you keep the aspect ratio correct on the sides/slopes? This has my brain in over-drive right now. - Also, need to try the foam. I cannot seem to cut through foam without the charring/yellowing...

@epiloglaser 6 месяцев назад

Hi Rick - the visual "stretching" of the logo at this size is very minimal, one mm or two or each side, so there is very little need to contract the artwork horizontally in this case. As for the polyethylene foam, we've used the same foam over and over for various projects like tool shadowing and decorate signage, it works great! Here is Laser Project: Sample Club we created with the source of the foam included in the article. www.epiloglaser.com/resources/sample-club/laser-cutting-foam-letters/ Hope this helps!