Always slurry the back of slabs on wet only for something to stick is either wet it or glue. slabs glue them don’t want re adjust 1, as you notice take half the ground up. Sbr cement good as any. But buying a proper slurry mix is much quick way to proper mix all the time ratio wise and doesn’t go off as quick. Tip sbr make you clean any spillages as it stains like mad. A use a cap of sbr in the cement when installed porcelain or sandstone limestone etc. tub slurry from marshalls or easy prime pavetuf brands depending on what 1 will cover anywhere from 20sqm to 30sqm per tub. Cracking work mark pal 😎🤟
@@markhep Yeah mate depending on brand £24 £34 bucks just and the water and whisk it up. Sbr and cement tends to go of quick in bucket more so in the summer. Takes some sucking it you put a slab down just cemndeg nothing on back slab go 10 mins lift will just peel off with minimal on back of slab. But with sbr/cement slurry or pre mix slurry will take the ground with ya and all the bed. Lol. In the past some times if using sbr av thrown a handful of sharp sand in the mix also.
Happy birthday mark if you can still read this 🤪🍺🍺. 39 , still just a wiper snapper . Love the herringbone pattern , not a big fan of the random pattern, smashing job as always 👌🏼🧱👍🏼
Cheers Wayne. Yes bloody freezing now lol. Was they a not. I not sure how to look at ads right. Must be because they longer vids. I wil see if I can alter it on next vid👍👍👍
Looks the biscuits 😋 hope your goin easy on the poison and if not make sure you ring the boss in the morning and tell him your throat is still killin you haahaaa
@@markhep yeah ha ha Main reason is because the tube is quite thin and you have to keep screwing the front on and off. It’s a cross between the point master and a coxx pointing gun which is similar to the blue faithful you find in a builders merchants
@@Southpoint2019 I definitely noticed that. My other gun is a lot bigger. And better. But think something has gone wrong on it. It does not seem to pump enough out. Minght think I need another big one lol👍👍👍😉
@@markhep tighten up the nuts at the end of the plunger that pushes the pug out. Failing that try a very small amount of WD on the mechanism where the spring is.