How to install a performance LED Steering wheel into your Toyota Supra or BMW. Follow this simple guide and you too can add a new look to your interior
I installed a wheel today on my Supra and it would not have been possible without your video. Thanks for making this video, it really helped me today bro.
Hey brother, just use a sharp Stanley knife blade (be careful they are sharp) and peel back some of the insulation on the factory wire. Once your opened it up to see the bar wire, separate some of it to make a hole. Put the wire from the steering wheel through it and twist it round to secure in place, then add a tiny bit of solder Cover with heat wrap or electrical tape
@@Simonstockton82when I'm driving or say drivetrain error and the car will turn off I have to wait for 30 to 40 minutes before I started and then I'll start back up again with no problem but sometimes that occurs and sometimes it doesn't now when I put it on the scanner when the first happens it says there's no communication my transmission thing turns off the actual light on it when I wait for a little while I'll start back up again but it can do it again now I've noticed when I plug unplug it it doesn't do that I was wondering if mine is the only one or maybe I've plugged something wrong or something I'm just trying to get to the bottom of it that's all
@@Simonstockton82 I really appreciate it because my car was in the accident and they're trying to tell me it's from the steering wheel and I know it shouldn't cause that problems you know what I mean so I really appreciate it thank you
Hey brother. The ground wire gets run to the ground for the steering wheel vibration unit. As you dismantle the wheel, it's bottom left of the motor unit 🤟
Hey bro, if you use the red wire to the 12v live you don't need to use the blue one. The blue is to make up the current if you use the horn switch because it doesn't flow enough zap zaps
Hey bro, of you use the red wire to the 12v live you don't need to use the blue one. The blue is to make up the current if you use the horn switch because it doesn't flow enough zap zaps
@@dylancarter8991 hey man I just cut away some of the insulating, pulled the wires apart and inserted the LED wheels power wire through the live one on the car, a tiny bit of solder and the recovered with tape
So i attempted this but the steering wheel teeth didn't match up so i had to put everything back. Now my air bag light is on. I did turn the car on without the air bag. Not sure how i can turn it off
@@anthytheboss did you take any pictures man. Our wheels are thr same so it should have lined up. They can be tight sometimes. As for the airbag light, you'll just need to clear the codes on the ecu.
@@Ghostinthe90s sure does mate. Hit up Justin Lazarus from East Coast Supra. He supplies to same wheels in the USA. Will make shipping so much cheaper for you bro. Tell him I sent you 👊