you forgot the mosfet that you selected in the cover. So that in the future the mosfet does not get somewhere where it can short the board. Otherwise, nice video
If you have a bunch power supply it will be easy for you.. the mosfet ment be good but the is something wrong in the board that make the mosfet to go off,, so if you have a power supply put the power from the current resistance and see if there is a problem on the board
Ok entiendo esta parte gracias y la alimentación entonces dónde se conecta para hacer esa prueba para que prenda la pantalla, el detalle es que en el vídeo no se logra ver
Wait i have a couple questions: Did u bridge the 3 pins at the bottom of the small mosvet? The second question if i had to leave it to change for 24 hours will the battery explode? And if the fan spins and stops, how do i fix that?
I put a power supply on the first pin of the big mosfet and the red light came on but when i did the power on like the video the all the lights but the red one was blinking and there was a blank screen, should i remove the first mosfet and do the connection and then try clearing the bias
If I get you rightly you said you put the power supply on the big first mosfet,,, its wrong.. when you connect the charger to the laptop where the 20v stop of the board????? First mosfet or second mosfet???
I put a bridge on the mosfet input to output 4pins to 3pins after I found our there is no short on the board.... So make sure you check for short first
