OK I know this is expensive...but hey you only buy one and this looks so amazing. However you might not say that when you start to fit it!
I have the 1250GS with riding lights. These riding lights use the 8mm formed hex angular 'hole' in the frame that the Lone Rider bracket uses. I took off the side panels and beak to get to this. However in the end I use the 8mm nut in the correct position over the 6mm light bolt and the original 6mm nut clamps the bracket perfectly. Lone Rider do not mention this but you will be able to work it out as I did.
When it comes to the GSA then the riding lights are mounted on the engine bars so this is much easier. You can fix the bracket without removing any side panels. The right hand side is much harder than the left but it will fit.
If you want both units of the guard to fold dow, makes sense, then you need to remove the bottom mushroom and we replace with a stainless steel bolt and rubber grommet that is with the kit, well that is the method that worked for us? Use silicone grease on the mushrooms to make it much easier. Have fun.
26 авг 2024
