My HPI savage flux has provisions for two steering servos, I opted to switch out the single 30 KG to a single 65 KG, so far so good. Really enjoy your wrenching videos.👍💯
I just love how this DBXLE is very similar to 8ight 2.0! After really getting a good look at yours i started to notice very very similar setup as my older model 8ight 2.0. DXLE is the bigger version from what I can tell.
The stock spektrum servo is trash. It's weak and breaks very easy. Mine didn't last 30 mins before a pin inside the servo bent. That servo might be good for the lighter 5th scales, but not the heavy losi. The servo I'm using now is a JX and it has a "claimed" 1,013 oz/in torque at 7.4v and it was only $60. I ordered it back in may and haven't had any problems with steering.
I just put the xlx 2 on mine on Monday, ran it for about 15 mins on Tues no problems. Wednesday was the day I was going for a full run. It didn't make it. The negative post on the esc broke, snapped right off. Flat land, no jumps, no rollovers. I'm sending it in for warranty. Depending on if they can repair or send me a new one, it can take any where from 3 weeks to 2.5 months+.
Yes yes there checking for ripple voltage to see it the wrong motors where used depending on the wind Y wined or D wined D wined will cause really high ripple and short the esc 🙏🔥🔥🔥
Hey Earl the DBXL looks slick I love the sound of that 1100 kv motor it sounds violent. Hey I just got a Losi SBR 2.O in today, I also ordered a 22 23 tooth pinion for it. Have you changed your pinion on your SBR ? if so what sizes worked for you? Thanks
I’m asking, because I really don’t know. Why don’t people use thermal paste between the motor and the heatsink like what is done with CPUs on computers? Thank you for the video.
The kit with the servo was cheaper then a $100.00 hitec I felt half the load should be better and last longer 👍👍but I did look at them my dbxle has a servox servo and that was $199.00 for a single as well still expensive 👍👍
@@earlmoorhead5555 it's worth it but I see what ya mean... I put that d845 in my o8s exb, dbxle 2.0, and my kraton 8s... My fav servo for the price... Got my local hobby shop to put them in inventory and he ordered 15 and they sold out in a month... Keep up the great work Earl 👌🏿 also u should try to dgi 1 inch extenders.. I put them in mine with the fast eddy bearings all the way around... 🍻
the screws are not short you are just building it wrong :P its not you everyone does this its an epidemic of bad teaching whoever showed you they were wrong as well so you see it's not just you :)
