Good morning Michael. Just stumbled across your videos this morning. Thank you very much for your content. This is some of the best detailed and clear information I have watched on 3D printing and Lychee Slicer. You briefly in this video went to "Normals" Mode, what exactly does that mode do. I noticed the color change, but what is that representing? Also, In another video you talk about the yellow checkerboard areas which represent areas that are going to require supporting. This is probably obvious, but if this is a large area or any of the yellow area for that matter, would you need to fill the entire yellow area with supports? I feel I am over supporting many of my prints. Thank you again for your content!
I was going to subscribe to pro, but so far, very little success with prints with Lychee. Won't spend the money for pro unless my success rate goes higher.
From one Michael P to another, use the gear icon to watch at whatever speed you'd like. For example, this Michael P watches everything at 2x speed, other Michael P's may need to watch at 0.5x. There's room on the internet for all types of Michael P's.
