Just installed that stock on my Century Arms C39v2 with milled receiver... word of advice... go to the hardware store and get a replacement 10/24 x 1/2” hex taper head bolt for the rear tang (less than .50¢). The supplied 3/8” will not work cuz the rear tang is thicker than on stamped receivers. The hex head should be tapered too. The hex is also the same size. I also added a drop of blue loctite. Everything Magpul makes for this specific AK will be a challenge to install due to more exacting tolerances on the receiver and no “give” at all. The fore end took a lot of rubber mallet love to get into place to allow the locking barrel ring to snap down. Have fun!!!
It's growing on me.....slowly. It is sexy but I also like the simple clean lines it came with. Can't wait for your honest post shooting workout review!
Nice. I have the MOE in OD green on my c39v2. Made a noticeable difference in comfort. Great vid. I have some vids of my V2 all decked out and shooting steel if your feeling froggy.
I have one and had a question, the wedge doesn’t line up, the more I tighten it it’ll work it’s way under the piece on the stock and be off. Any advice? Thank you