Thanks for the explanation. Videos like this are needed to help all new SR fans. What type of grease do you recommend to use. I have the original tube supplied by FLSUN but there are no references on their web page, manual or the tube I have as to what they recommend. Seems like a pretty basic thing they should post. Thanks again.
Thanks Dennis, one of my arms was was binding up, i cleaned the rails with WD40 first, then used your grease method, works perfectly but when i tighten the belt the arm starts to become harder to move... I checked that everything flows well. Little puzzled :-)
Good Day Dennis, Thank you for your videos. They have been most helpful. Would you please provide a link for the syringe and the syringe connector that you found on Amazon? I wish to purchase them. Thank you. Best Regards!
What happens if you don’t tune these belts? I’m asking because I’m having the same exactly issues with all 3 of my Super Racers but at different print times. I’m having globing and string at around 7-8 inches high off the build plate (to the paint if failure). But the base of the print is alway good. Any advice?
When installing the thumb screw on the side of the extruder, how tight to you make it? Do you run it all the way in? I think mine was about 1 full turn from tight.
This is exactly what I use... www.amazon.com/Lucas-Oil-10533-Lithium-Grease/dp/B004X70LZA/ref=sr_1_6?crid=MIC5ZWKR7WXP&keywords=white+lithium+grease&qid=1671753497&sprefix=white+lith%2Caps%2C85&sr=8-6
I use this: www.amazon.com/Lucas-Oil-10533-Lithium-Grease/dp/B004X70LZA/ref=sr_1_3?crid=KZAG8LX1X0AG&keywords=lithium+grease&qid=1673236086&sprefix=lithium+greas%2Caps%2C90&sr=8-3
Thanks for the videos Can you help me with the firmware update I did everything you said and it doesn't do anything on either of my super racers. Thanks Dave
@Dennis Gignac Thank you so much. It ended up being me and my computer. But I took care of both of them. Do you have any luck with supports? They drive me crazy. I'm learning Thank you again
In THEORY, it's great. In actual practice? Never get the same readings twice in a row. Tightening the lock screws changes it 5-25 hz. Gave up after an hour.