Make A Angle Grinder Attachment || Angle Grinder Hack 

Como fazer chanfrado

Was thinking the same thing, pretty over engineered for its limited use.

The table could have been done with a single section of angle iron: cut a too-wide length; mark, drill, tap as necessary; clamp a piece of scrap to those points at which the 90° bend will be needed and drill between the two to get the fold line; cut in from the ends, to the interior width of the supports, on (or just 'below') the angle; bend the two arms inward; install.

Larry Hutcherson Sr - You are right. Welding could have made the job much simpler. But if you don't have welding equipment, you have to necessarily follow the method shown to build the jig.

@@Bright8888 - You can make a welder by rewinding a couple of microwave transformers. I made a spot welder with one also.

Jj

Я тоже не люблю, когда применяют сварку. Ну нет её у меня! :-)

That's because he steals other people's ideas.

А без приспособы болгаркой работать не умеете? :-)))

No everybody have a welder machine remember there are persons 3th World,

Да

у него руки и без приспособ под правильными углами и все с первого раза и сразу... черт зависть)))

+

Nive work.😃😃

I might make a diy welding machine on my channel

Lidl welders are cheap as chips..£75 for a basic machine, get a good helmet gloves etc, and off you go.