Making 14" Round Wooden Plant Pot 【木工】14寸圓木花盤製作 

Papa Gleb, Thank you!

Bro, Thank you for your support!

Thank you. I used SketchUp to create a model first.

Divide 180 by number of pieces.

Hi Alan, thank you for bring up the question. The last customized piece needed because I couldn't get the exact angle cut. Here are a couple reasons might cause the problem. My tablesaw tabletop and the insert plate are not completely flat, so the angle I measured against the insert and the angle against the tabletop are different. I chose measured again the tabletop because it's more firmed. Also because my tablesaw is just a jobsite saw. It's not very powerful. The force I used to push the wood through was not even. Sometimes the blade will bend slightly that would add up to huge difference. So after cutting all of the pieces with two sided, the gap added up so big.

@@victorhe7200 I have the same saw so I’ll keep that in mind. Thanks again.

​@@drab31s You are welcome!

Thank you. First we need to know what rough diameter we want, then we can Sketchup to create a plan. Because the actual size of 2x4 stud is 1.75x3.75 inches. And after planing will be 1.5x3.5 inches. The 3.5 inches will be the max width for one of the outside edges. We can choose how many edges we need to create a circle in Sketchup. So we can play around the diameter, the edge width, and the edge numbers to see what fit our need.

Thank you. I used 78.7 degree to cut.

Victor He Thank you but if you divide 189 by 16 pieces you come to 11,25 so what’s is 78,7?

@@paulocaldas2390 I just used the SketchUp to build a simple model. that's what it came up.

Victor He Ok, thanks a lot.

@@paulocaldas2390 You are just measuring the other part of 90 degrees it’s the same angle.

Took me 5 days but even then it was still 20 sided 😅

Roughly, three days including the glue drying and the coating.

Aida, it's a traditional Chinese hand plane.

I used Minwax spar Urethane. I used on a few of my wooden pot, as long as you seal them well, I don't see any crack or mold. I think you can also use Epoxy Resin as well. Here is the product description: Minwax® Pro Series Spar Urethane is a professional, water-based, crystal clear protective finish that forms a protective barrier against rain, moisture and sunlight.

The outter size of pot is 14inches high, 14inches diameter. I prepared 16 pieces cut 2x4. 14 inches long, width 2.75 inches, thickness doesn't matter. Angel is 78.7 degree on two edges.

@@victorhe7200 Thank you, I will have a go at that.

I used SketchUp to create the model first. Depends on the thickness of the wood and the side of the pot. You can play around the number of segments of a circle in Sketchup, then give it the thickness you want. Then measure the angle from there.

❤❤ also I found it’s mathematical formula thanks

The height is 14 inches

I used Titebond 3, it's strong, good for outdoor, and food touched safe. Titebond 2 is ok too.

How tall is this planter