Massey Ferguson MF35 Hydraulic Pump Removal 

When I was in the motor trade, sticking clutches often happened after storage! The best way to free the clutch? First run the engine until it worms up. 2nd, jack up one rear wheel above the ground. Use solid axle stands. 3rd, select top gear siting on the seat and depress your clutch fully. 4th, with the clutch depressed: start your engine,!!! This works, due the backlash going throughout the gear train. Take it out of gear, You have just learned an old trick, which saves a lot of work/money. Enjoy 🔧🇬🇧😁

Thanks for taking your time to share this with us! :)

to much dirt around the work area.. one of the best tractors ever made. great rubber on it.

Hey Mary !

Whay not start with clean arond the part you romowe....think lite...

the rubber boot on the shifter will let the water in and the dip stick to

I can not believe you took this dirty tractor apart.. Clean up the tractor then take it apart..

Good job sir 👌👍

Your wife did a great job

Is there not something to disconnect before u lift the top off or is this the earlier 35,s and grey fergie s?

Its the same with mf165???

Water goes down wear the gear sticks are always the case

It would be awesome if we could see what your doing. 😂😂😂

Buenas Noches Me podrías enviar el tutorial l del desmonte de la Bomba Hidráulica del tres puntos del Massey Fergunson 290 por favor

Good with some dirt down the gearbox.

Condensation takes place just like in a fuel tank.

SOMETIMES NOT EVEN THE PUMP. THE CLUTCH. ESPECIALLY 2 STAGE.. YOU HAVE TO MAKE SURE THE PTO IS TURNING AT REAR WITH FORCE..... I KNOW THIS IS A WHILE BACK THOUGH....... or WHAT WAS THE PROBLEM

At 7:20 i saw ,what I believe to be,the problem....anyone else?

tradusir a español gracias

Bundy Bears Shed.

Moze li prevod na srpski jezik,hvala

les falta para ser mecanico

Your hydraulic/hydraulic pump quit cause your oil was full of water.

Your wife is fired

J