The time has finally come. Lots more testing to do but for now it held together. @mistermacgray #mistermacgray #chainsaw #racing Music used Warming Light by Jonny Easton RU-vid link • Beautiful Soft Piano M...
I think your idle circuit is too rich, it is loading up and tricking you into leaning the high speed circuit, that’s why it was stalling in the cut. These engines will settle down into an idle, not slow enough to stop the clutch from engaging, but they will idle. When you get the idle correct, it will respond better too. Those big sprockets tend to throw chains, the drivers are not in the bar groove at the base of the bar. Cool saw you have there
The old pipe it would idle and not spin the chain but with the new pipe it is pulling fuel via proper exhaust pulses. Also I don't want this saw to idle, I want the throttle blade to shut all of the way to kill it as I don't want a run away to happen but it is my primary way to shut it off next to ignition cut. The spark plug is dead on the money for mixture being where it should be. I would rather keep half way safe by nit being able to idle and the chain bit spin vs idling which this saw has no need to sit and idle.
