Miata NB Axle seal replacement 

I can’t remember exactly, but less than two hours. I was worried, but it was pretty easy. Removing the old seal took me the longest, but once I did it correctly , it came right out. Learning curve . Still no leaks FYI

Good to hear!

@@dennisstafford108 When installing the new seal, did the rigid ring/body of the seal sit flush with the housing, or did it sit below? I used the old seal to tap in the new seal and it is a few mm below the housing surface (and not 100% even)

@@davidd5424 at 2:57 you can see how mine looked, but it was flush if I remember and understand correctly.

@@dennisstafford108 Gotcha, it was a bit hard to tell with the moisture around the perimeter of the seal. Assuming no leaks to report on after install?

@@davidd5424 no leaks! I am sure yours will be fine as well