Тёмный

MIchael Wargo Flight Instruction: Dialing it in. RC Aircraft perfect setup 

Michael Wargo RC Flying and Instruction
Подписаться 15 тыс.
Просмотров 16 тыс.
50% 1

Precision Aerobatics and Hobbyking Team pilot, MIchael Wargo Discusses How to properly set up, trim and Dial in your plane
The videos below are part of the series and detailed look at how to Become a great RC pilot
Part 1
• MIchael Wargo Advanced...
Other instruction Videos
How to land a turbine JEt
• MIchael Wargo on how t...
Landing tips
• Michael Wargo: Tips,...
#wargo,#advanced, #instruction, #aerobatics, #rcairplane, #michaelwargo, ,#3daerobatics

Опубликовано:

 

1 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 29   
@xrx1113
@xrx1113 Год назад
Sailplane guy here did you guys see that thermal!!!
@amarinnemesis
@amarinnemesis Год назад
I watch this over and over again, always pickup something i didnt catch before. Man those Love bugs drive anyone crazy !
@786free1
@786free1 Год назад
Thanks but wouldn't the knife edge mix you've added affect your general flying?
@MichaelWargo
@MichaelWargo Год назад
Yes, but in a completely positive way.
@davidmcneill3809
@davidmcneill3809 6 месяцев назад
When you are trimming for knife edge, do you have than on a knew flight mode, or does that mixing reside all the time?
@MichaelWargo
@MichaelWargo 6 месяцев назад
I leave it on all the time. With the exception of high wing, it mostly helps in every part of the flight envelope.
@PhilipCrosby-md9xs
@PhilipCrosby-md9xs 5 месяцев назад
this is not for new pilots. You are pressing something on the transmitter but what is it? Which direction?
@MichaelWargo
@MichaelWargo 5 месяцев назад
I dont understand... Maybe give me a timing mark
@davidhall4398
@davidhall4398 2 года назад
I use the Scroll wheel in Flight in my Spektrum DX9 to trim out coupling I find it's nice to scroll the wheel and actually DIAL it in while flying. I just look which way it needs to be scrolled on the ground then go up and slowly scroll it until it's perfect.
@wernermoser3406
@wernermoser3406 Год назад
😆😆😆😂😂😂😂🤣🤣🤣🤣
@kittyhawk9886
@kittyhawk9886 11 месяцев назад
I said thank you 7 months ago. I say that again as I have progressed from a high wing trainer to a low wing trainer. The video makes even more sense. Thank you!
@Krash_fpv
@Krash_fpv 2 года назад
What prop size and pitch are you using on your pa planes? They are quiet and seem almost effortless and don't really seem like a typical 4.7 pitch slow fly
@MichaelWargo
@MichaelWargo 2 года назад
I use the recommended props always. It is important I fly it the way customers will.
@PiotrGulczi
@PiotrGulczi Год назад
Hello, If I can ask you about one question regarding trimming a new plane on its test flights, especially warbirds and high wing scale planes. On the forums there are couple tips how to do this right but they are all about 3D planes or other acrobatic planes. Can you guide me how do you do this? Especially checking your CG in flight - 3D planes are checked in inverted up-line or down-line but how it goes to lowwing warbird or highwing without symetrical airfoil?
@michaelkrailo5725
@michaelkrailo5725 2 года назад
Would you still mix out the roll coupling if it resulted in 52% mixing? That's what happened on my high wing omp hobbies big horn. It had a huge amount of roll coupling on both sides.
@MichaelWargo
@MichaelWargo 2 года назад
That’s a great question, and the answer is yes. I have a high wing plane that really is getting to be about 30 percent or mother. It’s the nature of a high wing in trainer. If that much Rutter mixing has any bad effect on anything else, you can always put it on a switch if you want to do knife edge or something like that. It should have a positive effect on most everything though
@michaelkrailo5725
@michaelkrailo5725 2 года назад
@@MichaelWargo I like the idea of putting it on a switch vice always on. At least I can test out the feeling between the two and decide how to go with it. I was just so surprised at how much mixing it took to get it to knife edge well.
@slange455
@slange455 Год назад
I setup low rates and high but hardly use low rates ….feel Ike I have just as much control with high and high expo
@Leon-mr5ff
@Leon-mr5ff 4 месяца назад
That cloud of birds thermalling was amazing to see!
@chillville5571
@chillville5571 Год назад
I thought i knew how to trim, i was wrong lol
@sbb8079
@sbb8079 Год назад
Huge help , Thank you
@thomaswilliams4944
@thomaswilliams4944 2 года назад
Thank you Michael!!
@kittyhawk9886
@kittyhawk9886 Год назад
Thank you!
@theoriginalrabbithole
@theoriginalrabbithole Год назад
This video is totally useless, unless someone owns your $1300.00 controller with all it's fancy touch-screen adjustments.
@MichaelWargo
@MichaelWargo Год назад
zNot true at all... These features are available on most if not all. Maybe except the most basic beginner radio...
@whidbey2
@whidbey2 2 месяца назад
You can do the mixing with most 6 channel and above modern radio
@NineGPull
@NineGPull 2 года назад
Who’s itching themselves while seeing all the insects? 🦟
@wernermoser3406
@wernermoser3406 Год назад
They are birds!😅😅😅😅
Далее
BEST COMPILATION of BAD (and CRASH) RC LANDINGS #5
9:46
Michael Wargo:   Tips, tricks and techniques on Landing.
12:06
RC Flight Trimming 101
4:31
Просмотров 4,3 тыс.
How to Flight Trim an RC Airplane
24:26
Просмотров 19 тыс.
RC planes CRASH COMPILATION #3 | 4K
19:17
Просмотров 223 тыс.